| поискавой системы для электроныых деталей |
|
PIC32MX795F512LT-80I/PF датащи(PDF) 174 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
PIC32MX795F512LT-80I/PF датащи(HTML) 174 Page - Microchip Technology |
|
174 / 256 page ![]() PIC32MX5XX/6XX/7XX DS61156G-page 174 © 2009-2011 Microchip Technology Inc. 28.3 On-Chip Voltage Regulator All PIC32MX5XX/6XX/7XX devices’ core and digital logic are designed to operate at a nominal 1.8V. To simplify system designs, most devices in the PIC32MX5XX/6XX/7XX family incorporate an on-chip regulator providing the required core logic voltage from VDD. A low-ESR capacitor (such as tantalum) must be connected to the VCAP/VCORE pin (see Figure 28-2). This helps to maintain the stability of the regulator. The recommended value for the filter capacitor is provided in Section 31.1 “DC Characteristics”. 28.3.1 ON-CHIP REGULATOR AND POR It takes a fixed delay for the on-chip regulator to generate an output. During this time, designated as TPU, code execution is disabled. TPU is applied every time the device resumes operation after any power-down, including Sleep mode. 28.3.2 ON-CHIP REGULATOR AND BOR PIC32MX5XX/6XX/7XX devices also have a simple brown-out capability. If the voltage supplied to the regulator is inadequate to maintain a regulated level, the regulator Reset circuitry will generate a Brown-out Reset. This event is captured by the BOR flag bit (RCON<1>). The brown-out voltage levels are specified in Section 31.1 “DC Characteristics”. 28.3.3 POWER-UP REQUIREMENTS The on-chip regulator is designed to meet the power-up requirements for the device. If the application does not use the regulator, strict power-up conditions must be adhered to. While powering up, VCORE must never exceed VDD by 0.3V. FIGURE 28-2: CONNECTIONS FOR THE ON-CHIP REGULATOR Note: It is important that the low-ESR capacitor is placed as close as possible to the VCAP/VCORE pin. VDD VCAP/VCORE VSS PIC32 CEFC(2) 3.3V(1) Note 1: These are typical operating voltages. Refer to Section 31.1 “DC Characteristics” for the full operating ranges of VDD and VCORE. 2: It is important that the low-ESR capacitor is placed as close as possible to the VCAP/VCORE pin. (10 μF typ) |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |