13892 datasheet(53/156 Pages) FREESCALE

53 / 156 page

Analog Integrated Circuit Device Data

Freescale Semiconductor

13892

FUNCTIONAL DEVICE OPERATION

CLOCK GENERATION AND REAL TIME CLOCK

TIME OF DAY ALARM

A Time Of Day Alarm (TODA) function can be used to turn on the application and alert the processor. If the application is

already on, the processor will be interrupted. The TODA and DAYA registers are used to set the alarm time. Only a single alarm

can be programmed at a time. When the TOD counter is equal to the value in TODA, and the DAY counter is equal to the value

in DAYA, the TODAI interrupt will be generated.

At initial power up of the application (application of the coin cell), the state of the TODA and DAYA registers will be all 1's. The

interrupt for the alarm (TODAI) is backed up by LICELL and will be valid at power up. If the mask bit for the TOD alarm (TODAM)

is high, then the TODAI interrupt is masked and the application will not turn on with the time of day alarm event

(TOD[16:0] = TODA[16:0] and DAY[14:0] = DAYA[14:0]). By default, the TODAM mask bit is set to 1, thus masking the interrupt

and turn on event.

TIMER RESET

As long as the supply at BP is valid, the real time clock will be supplied from VCORE. If not, it can be backed up from a coin

cell via the LICELL pin. When the backup voltage drops below RTCUVDET, the RTCPORB reset signal is generated and the

contents of the RTC will be reset. Additional registers backed up by coin cell will also reset with RTCPORB. To inform the

processor that the contents of the RTC are no longer valid due to the reset, a timer reset interrupt function is implemented with

the RTCRSTI bit.

RTC TIMER CALIBRATION

A clock calibration system is provided to adjust the 32,768 cycle counter that generates the 1.0 Hz timer for RTC timing

registers to comply with digital rights management specifications of ±50 ppm. This calibration system can be disabled, if not

needed to reduce the RTC current drain. The general implementation relies on the system processor to measure the 32.768 kHz

crystal oscillator against a higher frequency and more accurate system clock such as a TCXO. If the RTC timer needs a

correction, a 5 bit 2's complement calibration word can be sent via the SPI to compensate the RTC for inaccuracy in its reference

oscillator as defined in Table 18.

Table 18. RTC Calibration Settings

01111

+15

+458

00011

+92

00001

+31

00000

11111

-1

-31

11101

-3

-92

10001

-15

-458

10000

-16

-488

Note that the 32.768 kHz oscillator is not affected by RTCCAL settings. Calibration is only applied to the RTC time base

counter. Therefore, the frequency at the clock outputs CLK32K and CLK32KMCU are not affected.

The RTC system calibration is enabled by programming the RTCCALMODE[1:0] for desired behavior by operational mode.

Table 19. RTC Calibration Enabling

RTC Calibration disabled (default)

RTC Calibration enabled in all modes except coin cell only

Reserved for future use. Do not use.

RTC Calibration enabled in all modes

A slight increase in consumption will be seen when the calibration circuitry is activated. To minimize consumption and

maximize lifetime when the RTC system is maintained by the coin cell, the RTC Calibration circuitry can be automatically disabled

when main battery contact is lost, or if it is so deeply discharged that RTC power draw is switched to the coin cell (configured

with RTCCALMODE = 01).

Because of the low RTC consumption, RTC accuracy can be maintained through long periods of the application being shut

down, even after the main battery has discharged. However, it is noted that the calibration can only be as good as the RTCCAL

Code in RTCCAL[4:0]

Correction in Counts per 32768

Relative correction in ppm

RTCCALMODE

Function

13892 датащи(PDF) 53 Page - Freescale Semiconductor, Inc

13892 датащи(HTML) 53 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL