ATtiny25 datasheet(78/196 Pages) ATMEL

78 / 196 page

7598H–AVR–07/09

ATtiny25/45/85

• Bit 4– OCF0A: Output Compare Flag 0 A

The OCF0A bit is set when a Compare Match occurs between the Timer/Counter0 and the data

in OCR0A – Output Compare Register0. OCF0A is cleared by hardware when executing the cor-

responding interrupt handling vector. Alternatively, OCF0A is cleared by writing a logic one to

the flag. When the I-bit in SREG, OCIE0A (Timer/Counter0 Compare Match Interrupt Enable),

and OCF0A are set, the Timer/Counter0 Compare Match Interrupt is executed.

• Bit 3 – OCF0B: Output Compare Flag 0 B

The OCF0B bit is set when a Compare Match occurs between the Timer/Counter and the data in

OCR0B – Output Compare Register0 B. OCF0B is cleared by hardware when executing the cor-

responding interrupt handling vector. Alternatively, OCF0B is cleared by writing a logic one to

the flag. When the I-bit in SREG, OCIE0B (Timer/Counter Compare B Match Interrupt Enable),

and OCF0B are set, the Timer/Counter Compare Match Interrupt is executed.

• Bit 1 – TOV0: Timer/Counter0 Overflow Flag

The bit TOV0 is set when an overflow occurs in Timer/Counter0. TOV0 is cleared by hardware

when executing the corresponding interrupt handling vector. Alternatively, TOV0 is cleared by

writing a logic one to the flag. When the SREG I-bit, TOIE0 (Timer/Counter0 Overflow Interrupt

Enable), and TOV0 are set, the Timer/Counter0 Overflow interrupt is executed.

The setting of this flag is dependent of the WGM02:0 bit setting. Refer to Table 12-7, “Waveform

Generation Mode Bit Description” on page 75.

13. Timer/Counter Prescaler

The Timer/Counter can be clocked directly by the system clock (by setting the CSn2:0 = 1). This

provides the fastest operation, with a maximum Timer/Counter clock frequency equal to system

clock frequency (f

CLK_I/O). Alternatively, one of four taps from the prescaler can be used as a

clock source. The prescaled clock has a frequency of either f

CLK_I/O/8, fCLK_I/O/64, fCLK_I/O/256, or

CLK_I/O/1024.

13.1

Prescaler Reset

The prescaler is free running, i.e., operates independently of the Clock Select logic of the

Timer/Counter. Since the prescaler is not affected by the Timer/Counter’s clock select, the state

of the prescaler will have implications for situations where a prescaled clock is used. One exam-

ple of prescaling artifacts occurs when the timer is enabled and clocked by the prescaler (6 >

CSn2:0 > 1). The number of system clock cycles from when the timer is enabled to the first count

occurs can be from 1 to N+1 system clock cycles, where N equals the prescaler divisor (8, 64,

256, or 1024).

It is possible to use the Prescaler Reset for synchronizing the Timer/Counter to program

execution.

ATtiny25 датащи(PDF) 78 Page - ATMEL Corporation