TSB41BA3DIPFP datasheet(40/59 Pages) TI

40 / 59 page

(e)

(d)

(c)

(b)

(a)

D0–D7

CTL0, CTL1

SYSCLK

Link Controls CTL and D

PHY High-Impedance CTL and D Outputs

Interface Reset and Disable

TSB41BA3D

SLLS959A – DECEMBER 2008 – REVISED MARCH 2009 ............................................................................................................................................... www.ti.com

packet speed code is the same as the encoding for the received packet speed code (see Table 23). The link

cannot concatenate an S100 packet onto any higher-speed packet.

g. After regaining control of the interface, the PHY asserts at least one idle cycle before any subsequent status

transfer, receive operation, or transmit operation.

Figure 18. Cancelled/Null Packet Transmission

The sequence of events for a cancelled/null packet transmission is as follows:

a. Transmit operation initiated. PHY asserts grant on the CTL lines followed by idle to hand over control of the

interface to the link.

b. Optional idle cycle. The link can assert at most one idle cycle preceding assertion of hold. This idle cycle is

optional; the link is not required to assert idle preceding hold.

c. Optional hold cycles. The link can assert hold for up to 47 cycles preceding assertion of idle. These hold

cycle(s) are optional; the link is not required to assert hold preceding idle.

d. Null transmit termination. The null transmit operation is terminated by the link asserting two cycles of idle on

the CTL lines and then releasing the interface and returning control to the PHY. Note that the link can assert

idle for a total of three consecutive cycles if it asserts the optional first idle cycle but does not assert hold. It

is recommended that the link assert three cycles of idle to cancel a packet transmission if no hold cycles are

asserted. This ensures that either the link or PHY controls the interface in all cycles.

e. After regaining control of the interface, the PHY asserts at least one idle cycle before any subsequent status

transfer, receive operation, or transmit operation.

The LLC controls the state of the PHY-LLC interface using the LPS signal. The interface can be placed into a

reset state, a disabled state, or be made to initialize and then return to normal operation. When the interface is

not operational (whether reset, disabled, or in the process of initialization), the PHY cancels any outstanding bus

request or register read request, and ignores any requests made via the LREQ line. Additionally, any status

information generated by the PHY is not queued and does not cause a status transfer on restoration of the

interface to normal operation.

The LPS signal can be either a level signal or a pulsed signal, depending on whether the PHY-LLC interface is a

direct connection or is made across an isolation barrier. When an isolation barrier exists between the PHY and

LLC, the LPS signal must be pulsed. In a direct connection, the LPS signal can be either a pulsed or a level

signal. Timing parameters for the LPS signal are given in Table 24.

Submit Documentation Feedback

Product Folder Link(s): TSB41BA3D

TSB41BA3DIPFP датащи(PDF) 40 Page - Texas Instruments

TSB41BA3DIPFP датащи(HTML) 40 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59

датащи скачать

ссылки URL