AT25DF256 datasheet(10/47 Pages) RENESAS

номер детали	AT25DF256

подробное описание детали	256-Kbit, 1.65 V Minimum SPI Serial Flash Memory with Dual-Read Support

PDF	47 Pages

Scroll/Zoom	100%

производитель	RENESAS [Renesas Technology Corp]

домашняя страница	http://www.renesas.com

Logo

10 / 47 page

DS-AT25DF256-035 Rev.G

Page 10

2024-01-08

AT25DF256 Datasheet

Device Operation

The AT25DF256 is controlled by a set of commands that are sent from a host controller, commonly referred to as

the SPI Master. The SPI Master communicates with the AT25DF256 through the SPI bus, which consists of four

signal lines: Chip Select (CS), Serial Clock (SCK), Serial Input (SI), and Serial Output (SO).

The SPI protocol defines four modes of operation (0, 1, 2, or 3), with each mode differing in respect to the SCK

polarity and phase, as well as how the polarity and phase control the flow of data on the SPI bus. The AT25DF256

supports the two most common modes, SPI Modes 0 and 3. The only difference between SPI Modes 0 and 3 is

the polarity of the SCK signal when in the inactive state (when the SPI Master is in standby mode and not

transferring any data). With SPI Modes 0 and 3, data is latched in on the rising edge of SCK and output on the

falling edge of SCK.

Figure 6. SPI Mode 0 and 3

5.1

Dual Output Read

The AT25DF256 features a Dual-Output Read mode that allow two bits of data to be clocked out of the device

every clock cycle to improve throughput. To do this, both the SI and SO pins are used as outputs for the transfer

of data bytes. With the Dual-Output Read Array command, the SI pin becomes an output along with the SO pin.

6&.

06%

/6%

06%

/6%

AT25DF256 датащи(PDF) 10 Page - Renesas Technology Corp