| поискавой системы для электроныых деталей |
|
ADF4382ABCCZ датащи(PDF) 6 Page - Analog Devices |
|
|
|||||||||||||||||||||||||||||
ADF4382ABCCZ датащи(HTML) 6 Page - Analog Devices |
|
6 / 82 page ![]() Data Sheet ADF4382A SPECIFICATIONS analog.com Rev. A | 6 of 82 Parameter Symbol Min Typ Max Unit Test Conditions/Comments LOGIC OUTPUTS (SDIO, SDO, LKDET, and MUXOUT) Output High Voltage (1.8 V Mode) VOH-1.8V 1.5 1.8 2 V Output high current (IOH) = 500 μA, 1.8 V output selected (default setting) Output High Voltage (3.3 V Mode) VOH-3V V3.3V − 0.4 IOH = 500 μA, 3.3 V output selected, set by the voltage on the V3_LDO pin, and CMOS_OV can set to either 1.8 V or 3.3 V logic Output Low Voltage VOL 0.4 V Output low current (IOL) = 500 μA SDO High-Z Leakage IZH/IZL ±1 μA POWER SUPPLIES Device Setup is default configuration for all Supply Current specifications unless noted below. V5_VCO Supply Range VV5_VCO 4.75 5 5.25 V V5_CAL Supply Range VV5_CAL 4.75 5 5.25 V V5_CP Supply Range VV5_CP 4.75 5 5.25 V V3.3V_1 Supply Range V3.3V_1 3.15 3.3 3.45 V Group 1: V3_LS, V3_LDO, V3_REF, V3_PFD, V3_NDIV, and V3_SYNC V3.3V_2 Supply Range V3.3V_2 3.15 3.3 3.45 V Group 2: V3_RFOUT1, V3_RFOUT2, V3_VCO, and V3_OUTDIV V5_VCO Supply Current I5V_VCO 140 195 mA fOUT = 11.5 GHz to 21GHz, RFOUT_DIV = 0, maximum charge pump current V5_CAL Supply Current I5V_CAL 105 215 μA 15 mA During VCO calibration V5_CP Supply Current I5V_CP 60 70 mA ICP = 11.1 mA V3.3V_1 Supply Current I3.3V_1 200 240 mA V3.3V_2 Supply Current I3.3V_2 310 340 mA PD_RFOUT1 = 0, PD_RFOUT2 = 0, RFOUT1_OPWR = 11 and RFOUT2_OPWR = 11 (maximum power) Typical Power Dissipation PDIS 2.2 to 2.6 PD_RFOUT1 = 1, PD_RFOUT2 = 0, RFOUT1_OPWR = 11 RFOUT2_OPWR = 11 (maximum power) Typical Power Down Current 3.3 V 3.1 mA PD_ALL =1, I3.3V_1 + I3.3V_2 5 V 340 uA PD_ALL=1, IVCO-5V + ICAL-5V + ICP-5V Typical Disable Current 3.3 V Supplies 710 uA CE=LOW, I3.3V_1 + I3.3V_2 5 V Supplies 340 uA CE=LOW, IVCO-5V + ICAL-5V + ICP-5V RF OUTPUT NOISE CHARACTERISTICS RF Output = 20 GHz VCO noise in open-loop conditions, and offset from 20 GHz carrier Phase Noise Floor −156 dBc/Hz 100 KHz Offset −103 dBc/Hz 1 MHz Offset −125 dBc/Hz 10 MHz Offset −144 dBc/Hz RF Output = 14 GHz VCO noise in open-loop conditions and offset from 14 GHz carrier Phase Noise Floor −156 dBc/Hz 100 KHz Offset −106 dBc/Hz 1 MHz Offset −125 dBc/Hz 10 MHz Offset −145 dBc/Hz |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |