| поискавой системы для электроныых деталей |
|
CS4525 датащи(PDF) 81 Page - Cirrus Logic |
|
|
|||||||||||||||||||||||||||||
CS4525 датащи(HTML) 81 Page - Cirrus Logic |
|
81 / 91 page ![]() DS726A1 81 CS4525 9.18 Power Control (Address 5Fh) 9.18.1 Select VD Level (SelectVD) Default = 1 Function: This bit selects between a VD of 2.5 V or 3.3 V when the LVD pin is connected to DGND. This bit is ignored when the LVD pin is connected to VD. 9.18.2 Power Down ADC (PDnADC) Default = 1 Function: The ADC will enter a power down state when this bit is enabled. 9.18.3 Power Down PWM Power Output X (PDnOutX) Default = 1 Function: When set, the specific PWM power output will enter a power-down state. Only the output power stage is powered down. The PWM modulator is not affected, nor is the setup or delay register values. When set to normal operation, the specific output will power up according to the state of the RmpSpd[1:0] bits and the channel output configuration selected. When transitioning from normal operation to power down, the specific output will power down according to the state of the RmpSpd[1:0] bits and the channel output con- figuration selected. 9.18.4 Power Down (PDnAll) Default = 1 Function: The entire device will enter a low-power state when this function is enabled, and the contents of the control registers are retained in this mode. The power-down bit defaults to ‘enabled’ on power-up and must be disabled before normal operation can occur. 7 6 5 432 10 Reserved Reserved SelectVD PDnADC PDnOut3/4 PDnOut2 PDnOut1 PDnAll SelectVD Setting Selected VD Level 0 .......................................... VD = 2.5 V. 1 .......................................... VD = 3.3 V. PDnADC Setting ADC Power-Down State 0 .......................................... Normal ADC operation. 1 .......................................... ADC power-down enabled. PDnChX Setting Power Output X Power-Down State 0 .......................................... Normal power output X operation. 1 .......................................... Power output X power-down enabled. PDnAll Setting Device Power-Down State 0 .......................................... Normal device operation. 1 .......................................... Device power-down enabled. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |