AT25QL641 datasheet(53/80 Pages) RENESAS

53 / 80 page

DS-AT25QL641-130 Rev. G

Page 53

Sep 14, 2022

AT25QL641 Datasheet

8.29 Enable QPI (38h)

The AT25QL641 supports both the Standard/Dual/Quad Serial Peripheral interface (SPI) and the Quad

Peripheral Interface (QPI) modes. However, SPI mode and QPI mode cannot be used at the same time. The

Enable QPI command is the only way to switch the device from SPI mode to QPI mode.

In order to switch the device to QPI mode, the Quad Enable (QE) bit in Status Register 2 must be set to 1 first,

and an Enable QPI command must be issued. If the Quad Enable (QE) bit is 0, the Enable QPI command is

ignored and the device remains in SPI mode.

After power-up, the default state of the device is SPI mode. See the command set Table 8 for all the commands

supported in SPI mode and the command See Table 11 for all the commands supported in QPI mode.

When the device is switched from SPI mode to QPI mode, the existing write enable and program/erase suspend

status, and the wrap length setting remains unchanged.

Figure 51. Enable QPI Command (SPI Mode only)

8.30 Disable QPI (FFh)

By issuing Disable QPI (FFh) command, the device is reset SPI mode. When the device is switched from QPI

mode to SPI mode, the existing Write Enable Latch (WEL) and Program/Erase Suspend status, and the Wrap

Length setting remains unchanged.

Figure 52. Disable QPI Command for QPI Mode

246

Mode 3

Mode 0

Mode 3

Mode 0

High-Impedance

SCK

Command (38h)

SCK

Command

(FFh)

Mode 3

Mode 0

Mode 3

Mode 0

AT25QL641 датащи(PDF) 53 Page - Renesas Technology Corp