FUSB308B datasheet(9/53 Pages) ONSEMI

9 / 53 page

FUSB308B

www.onsemi.com

Figure 7. Transmit State Machine

TRANSMIT[2:0] < 101b written

Message sent to PHY

CRCReceiveTimer

Timeout

GoodCRC response from

PHY layer

(RXHEADH[3:1] != TXHEADH[3:1] (MessageID mismatch) |

TRANSMIT[2:0] != RXSTAT[2:0] (SOP mismatch) )

RetryCounter

> NRETRIES

GoodCRC with MessageID and SOP match

PRL_Tx_Check_RetryCounter

Actions on entry:

If DFP or UFP,Increment and check

RetryCounter

PRL_Tx_Transmission_Error

Actions on entry:

Set ALERTL.I_TXFAIL interrupt

PRL_Tx_Construct_Message

Actions on entry:

Pass TXBYTECNT bytes from

TXHEADL and TXHEADH and

TXDATA to PHY

PRL_Tx_Wait_for_PHY_response

Actions on entry:

Initialize and run CRCReceiveTimer

PRL_Tx_Match_MessageID

Actions on entry:

Match Extracted MessageID and

response MessageID

PRL_Tx_Message_Sent

Actions on entry:

Set ALERTL.I_TXSUCC

PRL_Tx_Wait_for_

Message_Request

Actions on entry:

Reset RetryCounter.

ProtocolTransmit

(Collision detected and now bus idle)

I_TX_MSG_DISC && bus idle

RetryCounter ≤

NRETRIES

Protocol Layer message reception

in PRL_Rx_Message_Discard state

4. The CRCReceiveTimer is only started after the FUSB305 has sent the message. If the message is not sent due to a busy channel

then the CRCReceiveTimer will not be started.

5. This Indication is sent by the PHY layer when a message has been discarded due to CC being busy, and after CC becomes idle

again. The CRCReceiveTimer is not running in this case since no message has been sent.

(Note 5)

(Note 4)

FUSB308B датащи(PDF) 9 Page - ON Semiconductor

FUSB308B датащи(HTML) 9 Page - ON Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

датащи скачать

ссылки URL