L6751 datasheet(21/59 Pages) STMICROELECTRONICS

номер детали	L6751

подробное описание детали	Digitally controlled dual PWM for Intel VR12 and AMD SVI

PDF	59 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

21 / 59 page

L6751

Device configuration and pinstrapping tables

Doc ID 023992 Rev 1

21/59

Device configuration and pinstrapping tables

The L6751 features a universal serial data bus fully compliant with Intel VR12/IMVP7

Protocol rev 1.5, document #456098 and AMD SVI specifications, document #40182. To

guarantee proper device and CPU operation, refer to these documents for bus design,

layout guidelines and any additional information required for the bus architecture. Different

platforms may require different pull-up impedance on the SVI bus. Impedance matching and

spacing among SVI bus lines must be followed.

The controller configures itself automatically upon detection of different pinstrappings which

are monitored at the IC power-up. See Table 6, 8, 9, 10, and 11 for details.

4.1

JMode

When enabled, multi-phase acts as if in DDR mode, while single-phase is an independent

regulator with 0.75 V fixed reference (load-line disabled - TM can be used as enable for the

single-phase).

Output voltage higher than the internal reference may be achieved by adding a proper

resistor divider (RA, RB - see Figure 4). To maintain precision in output voltage regulation, it

is recommended to provide both SFBR and SRGND with the same divider.

Equation 1

Figure 4.

JMode: voltage positioning

OUT

0.750V

-----------------------

⋅

0.750V

SFB

SCOMP

SVSEN

SFBR

RFB

To Vout

(Remote Sense)

SRGND

AM14812v1

L6751 датащи(PDF) 21 Page - STMicroelectronics