L6751 datasheet(53/59 Pages) STMICROELECTRONICS

53 / 59 page

L6751

PMBus support (preliminary)

Doc ID 023992 Rev 1

53/59

Note:

Applies to multi-phase only.

Applies to single-phase only.

12.1

Enabling the device through PMBus

The default condition for the L6751 is to power up through the EN pin ignoring PMBus

commands. By properly setting the ON_OFF_CONFIG command, it is also possible to let

the device ignore the EN pin acting only as a consequence of the OPERATION command

issued.

12.2

Controlling Vout through PMBus

Vout can be set independently from SetVID commands issued through the SVI interface by

using PMBus. Two main modes can be identified as:

–

Offset above SVI commanded voltage. By enabling the MARGIN mode through

the OPERATION command and by commanding the MARGIN_HIGH and

MARGIN_LOW registers, it is possible to dynamically control an offset above the

output voltage commanded through the SVI bus.

–

Fixed Vout regardless of SVI. It is necessary to enter DEBUG_MODE. In this

condition, commands from SVI are acknowledged but not executed and

VOUT_COMMAND controls the voltage regulated on the output. The L6751 can

enter and exit DEBUG_MODE anytime. Upon any transition, Vout remains un-

changed and only the next-coming command affects the output voltage positioning

(i.e. when exiting DEBUG_MODE, returning to SVI domain, output voltage

remains unchanged until the next SetVID command).

STATUS_INPUT

R Byte

Status information on the input warning and fault

STATUS_MFR_SPECI

FIC

R Byte

Manufacturer specific status

Table 16.

Supported commands

Command

Per

Rail

Code

[Hex]

Mode

Comments

L6751 датащи(PDF) 53 Page - STMicroelectronics

L6751 датащи(HTML) 53 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59

датащи скачать

ссылки URL