RF64 datasheet(72/76 Pages) ETC2

номер детали	RF64

подробное описание детали	ADVANCED COMMUNICATIONS & SENSING

PDF	76 Pages

Scroll/Zoom	100%

производитель	ETC2 [List of Unclassifed Manufacturers]

домашняя страница

Logo

72 / 76 page

ADVANCED COMMUNICATIONS & SENSING

Page 72 of 76

RF64

Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com

7.4. Reset of the Chip

A power-on reset of the RF64 is triggered at power up. Additionally, a manual reset can be issued by controlling pin

13.

7.4.1. POR

If the application requires the disconnection of VDD from the RF64, despite of the extremely low Sleep Mode

current, the user should wait for 10 ms from of the end of the POR cycle before commencing communications over

the SPI bus. Pin 13 (TEST8) should be left floating during the POR sequence.

VDD

Pin 13

(output)

Undefined

Wait for

10 ms

Chip is ready from

this point on

Figure 54: POR Timing Diagram

Please note that any CLKOUT activity can also be used to detect that the chip is ready.

7.4.2. Manual Reset

A manual reset of the RF64 is possible even for applications in which VDD cannot be physically disconnected.

Pin 13 should be pulled high for a hundred microseconds, and then released. The user should then wait for 5 ms

before using the chip.

Figure 55: Manual Reset Timing Diagram

Please note that while pin 13 is driven high, an over current consumption of up to ten milliamps can be seen on

VDD.

RF64 датащи(PDF) 72 Page - List of Unclassifed Manufacturers