DSPIC30F2010 datasheet(89/202 Pages) MICROCHIP

89 / 202 page

DS70118J-page 89

dsPIC30F2010

14.14 PWM Special Event Trigger

The PWM module has a special event trigger that

allows A/D conversions to be synchronized to the PWM

time base. The A/D sampling and conversion time may

be programmed to occur at any point within the PWM

period. The special event trigger allows the user to min-

imize the delay between the time when A/D conversion

results are acquired, and the time when the duty cycle

value is updated.

The PWM special event trigger has an SFR named

SEVTCMP, and five control bits to control its operation.

The PTMR value for which a special event trigger

should occur is loaded into the SEVTCMP register.

When the PWM time base is in an Up/Down Counting

mode, an additional control bit is required to specify the

counting phase for the special event trigger. The count

phase is selected using the SEVTDIR control bit in the

SEVTCMP SFR. If the SEVTDIR bit is cleared, the spe-

cial event trigger will occur on the upward counting

cycle of the PWM time base. If the SEVTDIR bit is set,

the special event trigger will occur on the downward

count cycle of the PWM time base. The SEVTDIR

control bit has no effect unless the PWM time base is

configured for an Up/Down Counting mode.

14.14.1

SPECIAL EVENT TRIGGER

POSTSCALER

The PWM special event trigger has a postscaler that

allows a 1:1 to 1:16 postscale ratio. The postscaler is

configured by writing the SEVOPS<3:0> control bits in

the PWMCON2 SFR.

The special event output postscaler is cleared on the

following events:

• Any write to the SEVTCMP register

• Any device Reset

14.15 PWM Operation During CPU Sleep

Mode

The FLTA input pin has the ability to wake the CPU

from Sleep mode. The PWM module generates an

interrupt if the FLTA pin is driven low while in Sleep.

14.16 PWM Operation During CPU Idle

Mode

The PTCON SFR contains a PTSIDL control bit. This

bit determines if the PWM module will continue to

operate or stop when the device enters Idle mode. If

PTSIDL = 0, the module will continue to operate. If

PTSIDL = 1, the module will stop operation as long as

the CPU remains in Idle mode.

DSPIC30F2010 датащи(PDF) 89 Page - Microchip Technology

DSPIC30F2010 датащи(HTML) 89 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL