7641 datasheet(49/385 Pages) RENESAS

49 / 385 page

Rev.2.00

Aug 28, 2006

page 32 of 113

7641 Group

REJ09B0336-0200

HARDWARE

FUNCTIONAL DESCRIPTION

q SPI Compatible Mode Operation

Setting the SPI Mode Select Bit (bit 0 of SIOCON2) puts the serial

I/O in SPI compatible mode. The Synchronous Clock Select Bit

(bit 6 of SIOCON1) determines whether the serial I/O is an SPI

master or slave. When the external clock is selected (“0”), the se-

rial I/O is in slave mode; When the internal clock is selected (“1”),

the serial I/O is in master mode.

In SPI compatible mode the SRXD pin functions as a MISO (Mas-

ter In/Slave Out) pin and the STXD pin functions as a MOSI

(Master Out/Slave In) pin.

In slave mode the transmit data is output from the MISO pin and

the receive data is input from the MISO pin. The SRDY pin func-

tions as the chip-select signal input pin from an external.

In master mode the transmit data is output from the MOSI pin and

the receive data is input from the MISO pin. The SRDY pin func-

tions as the chip-select signal output pin to an external.

• Slave Mode Operation

In slave mode of SPI compatible mode 4 types of clock polarity

and clock phase can be usable by bits 3 and 4 of serial I/O control

If the SRDY pin is held “H”, the shift clock is inhibited, the serial I/

O counter is set to “7”. If the SRDY pin is held “L”, then the shift

clock will start.

Make sure during transfer to maintain the SRDY input at “L” and

not to write data to the serial I/O counter.

Figure 25 shows the serial I/O timing.

7641 датащи(PDF) 49 Page - Renesas Technology Corp