7641 datasheet(38/385 Pages) RENESAS

38 / 385 page

Rev.2.00

Aug 28, 2006

page 21 of 113

7641 Group

REJ09B0336-0200

HARDWARE

FUNCTIONAL DESCRIPTION

INTERRUPTS

There are twenty-four interrupt sources: five externals, eighteen

internals, and one software.

Interrupt Control

Each interrupt except the BRK instruction interrupt has both an Inter-

rupt Request Bit and an Interrupt Enable Bit, and is controlled by the

Interrupt Disable Flag (I). An interrupt occurs if the corresponding

Interrupt Request and Enable Bits are “1” and the Interrupt Disable

Flag is “0”.

Interrupt Enable Bits can be set or cleared by software. Interrupt Re-

quest Bits can be cleared by software, but cannot be set by software.

Additionally, an active edge of INT1 and INT2 can be selected by

using the interrupt edge select register (address 001116); an active

edge of CNTR0 can be done by using the timer X mode register

(address 002716); an active edge of CNTR1 can be done by using

the timer Y mode register (address 002816).

The BRK instruction interrupt and reset cannot be disabled with any

flag or bit. The I Flag disables all interrupts except the BRK instruc-

tion interrupt and reset. If several interrupts requests occur at the

same time, the interrupt with the highest priority is accepted first.

Interrupt Operation

When an interrupt request occurs, the following operations are auto-

matically performed:

1. The processing being executed is stopped.

2. The contents of the program counter and processor status reg-

ister are automatically pushed onto the stack.

3. The Interrupt Disable Flag is set and the corresponding in-

terrupt request bit is cleared.

4. The interrupt jump destination address is read from the vector

table into the program counter.

sNotes

When setting the followings, the interrupt request bit may be set to

“1”.

•When setting external interrupt active edge

Related register: Interrupt polarity select register (address 001116)

Timer X mode register (address 002716)

Timer Y mode register (address 002816)

When not requiring for the interrupt occurrence synchronized with

these setting, take the following sequence.

➀Set the corresponding Interrupt Enable Bit to “0” (disabled).

➁Set the Interrupt Edge Select Bit (Active Edge Switch Bit).

➂Set the corresponding Interrupt Request Bit to “0” after 1 or more

instructions have been executed.

➃Set the corresponding Interrupt Enable Bit to “1” (enabled).

Fig. 16 Interrupt control

Interrupt request bit

Interrupt enable bit

Interrupt disable flag (I)

BRK instruction

Reset

Interrupt request

7641 датащи(PDF) 38 Page - Renesas Technology Corp

7641 датащи(HTML) 38 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL