AT83SND2CMP3 datasheet(49/97 Pages) ATMEL

49 / 97 page

AT83SND2CMP3

7524B–MP3–05/06

USB Interrupt System

Interrupt System Priorities

Figure 35.

USB Interrupt Control System

Table 1.

Priority Levels

USB Interrupt Control System

As shown in Figure 36, many events can produce a USB interrupt:

•

TXCMPL: Transmitted In Data. This bit is set by hardware when the Host accept a

In packet.

•

RXOUTB0: Received Out Data Bank 0. This bit is set by hardware when an Out

packet is accepted by the endpoint and stored in bank 0.

•

RXOUTB1: Received Out Data Bank 1 (only for Ping-pong endpoints). This bit is set

by hardware when an Out packet is accepted by the endpoint and stored in bank 1.

•

RXSETUP: Received Setup. This bit is set by hardware when an SETUP packet is

accepted by the endpoint.

•

STLCRC: STALLED (only for Control, Bulk and Interrupt endpoints). This bit is set

by hardware when a STALL handshake has been sent as requested by STALLRQ,

and is reset by hardware when a SETUP packet is received.

•

SOFINT: Start of Frame Interrupt . This bit is set by hardware when a USB start of

frame packet has been received.

•

WUPCPU: Wake-Up CPU Interrupt. This bit is set by hardware when a USB resume

is detected on the USB bus, after a SUSPEND state.

•

SPINT: Suspend Interrupt. This bit is set by hardware when a USB suspend is

detected on the USB bus.

EUSB

IE1.6

IE0.7

USB

Controller

IPH/L

Interrupt Enable

Lowest Priority Interrupts

Priority Enable

D+

D-

IPHUSB

IPLUSB

USB Priority Level

0..................Lowest

3..................Highest

AT83SND2CMP3 датащи(PDF) 49 Page - ATMEL Corporation

AT83SND2CMP3 датащи(HTML) 49 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97

датащи скачать

ссылки URL