56F803 datasheet(11/57 Pages) FREESCALE

11 / 57 page

56F803 Technical Data, Rev. 16

Freescale Semiconductor

software routines that can be used to program the main Program and Data Flash memory areas. Both

Program and Data Flash memories can be independently bulk–erased or erased in page sizes of 256 words.

The Boot Flash memory can also be either bulk- or page-erased.

A key application-specific feature of the 56F803 is the inclusion of a Pulse Width Modulator (PWM)

module. This module incorporates three complementary, individually programmable PWM signal outputs

(the module is also capable of supporting three independent PWM functions, for a total of six PWM

outputs) to enhance motor control functionality. Complementary operation permits programmable dead

time insertion, distortion correction via current sensing by software, and separate top and bottom output

polarity control. The up-counter value is programmable to support a continuously variable PWM

frequency. Edge- and center-aligned synchronous pulse width control (0% to 100% modulation) is

supported. The device is capable of controlling most motor types: ACIM (AC Induction Motors), both

BDC and BLDC (Brush and Brushless DC motors), SRM and VRM (Switched and Variable Reluctance

Motors), and stepper motors. The PWM incorporates fault protection and cycle-by-cycle current limiting

with sufficient output drive capability to directly drive standard opto-isolators. A “smoke-inhibit”,

write-once protection feature for key parameters and patented PWM waveform distortion correction

circuit are also provided. The PWM is double-buffered and includes interrupt controls to permit integral

reload rates to be programmable from 1 to 16. The PWM module provides a reference output to

synchronize the ADC.

The 56F803 incorporates a separate Quadrature Decoder capable of capturing all four transitions on the

two-phase inputs, permitting generation of a number proportional to actual position. Speed computation

capabilities accommodate both fast and slow moving shafts. The integrated watchdog timer in the

Quadrature Decoder can be programmed with a time-out value to alarm when no shaft motion is detected.

Each input is filtered to ensure only true transitions are recorded.

This controller also provides a full set of standard programmable peripherals that include a Serial

Communications Interface (SCI), one Serial Peripheral Interface (SPI), and four Quad Timers. Any of

these interfaces can be used as General Purpose Input/Outputs (GPIO) if that function is not required. A

Controller Area Network interface (CAN Version 2.0 A/B-compliant) and an internal interrupt controller

are also included on the 56F803.

1.3 State of the Art Development Environment

•

Processor ExpertTM (PE) provides a Rapid Application Design (RAD) tool that combines easy-to-use

component-based software application creation with an expert knowledge system.

•

The Code Warrior Integrated Development Environment is a sophisticated tool for code navigation,

compiling, and debugging. A complete set of evaluation modules (EVMs) and development system cards

will support concurrent engineering. Together, PE, Code Warrior and EVMs create a complete, scalable

tools solution for easy, fast, and efficient development.

56F803 датащи(PDF) 11 Page - Freescale Semiconductor, Inc