HC705CT4GRSSLASHD datasheet(84/152 Pages) NXP

84 / 152 page

Core Timer

General Release Specification

MC68HC705CT4 — Rev. 2.0

Core Timer

MOTOROLA

10.5 Computer Operating Properly (COP) Reset

The COP watchdog timer function is implemented on this device by

using the output of the RTI circuit and further dividing it by eight. The

minimum COP reset rates are listed in Table 10-2. If the COP circuit

times out, an internal reset is generated and the normal reset vector is

fetched. Preventing a COP timeout or clearing the COP is accomplished

by writing a logic 0 to bit 0 of address $1FF0. When the COP is cleared,

only the final divide-by-eight stage (output of the RTI) is cleared.

If the COP watchdog timer is allowed to time out, an internal reset is

generated to reset the MCU. In addition, the RESET pin is pulled low for

a minimum of one E-clock cycle for emulation purposes.

The COP remains enabled after execution of the WAIT instruction and

all associated operations apply. If the STOP instruction is disabled,

execution of STOP instruction causes the CPU to execute a NOP

instruction. In addition, the COP is prohibited from being held in RESET.

This prevents a device lock-up condition.

This COP’s objective is to make it impossible for this device to become

stuck or locked-up and to be sure the COP is able to rescue the part from

any situation where it might entrap itself in abnormal or unintended

behavior. This function is a mask option.

10.6 Timer During Wait Mode

The CPU clock halts during wait mode, but the timer remains active. If

interrupts are enabled, a timer interrupt will cause the processor to exit

wait mode. The COP is always enabled while in user mode.

10.7 Core Timer Power Supply Source

The core timer is supplied by VDD and VSS. VDD2 and VSS2 are not

needed here because this module is not susceptible to supply noise.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705CT4GRS/D датащи(PDF) 84 Page - NXP Semiconductors