HC705CT4GRSSLASHD datasheet(76/152 Pages) NXP

76 / 152 page

Synchronous Serial Interface (SSI)

General Release Specification

MC68HC705CT4 — Rev. 2.0

Synchronous Serial Interface (SSI)

MOTOROLA

9.4.3 SSI Data Register

This register is located at address $001D and is both the transmit and

receive data register. This system is not double buffered, but any writes

to this register during transfers are masked and will not destroy the

previous contents. The SDR can be read at any time, but, if a transfer is

in progress the results may be ambiguous. The contents of this register

could be altered whenever the CPOL bit is altered. This register should

be written to only upon completion of a transfer, after the SF flag has

been cleared. Otherwise, the new data will not be stored.

For an SSI configured as a master, to initiate a transfer, the data register

write must occur after the SSI is enabled.

9.5 Operation During Wait Mode

The CPU clock halts during wait mode, but the SSI remains active. If

interrupts are enabled, an SSI interrupt will cause the processor to exit

wait mode.

9.6 Operation During Stop Mode

In stop mode, the SSI halts operation. The SDIO and SCK pins will

maintain their states.

If the SSI is nearing completion of a transfer when the stop mode is

entered, it might be possible for the SSI to generate an interrupt request

and thus cause the processor immediately to exit stop mode. To prevent

Address:

$001D

Bit 7

654321

Bit 0

Read:

Write:

Reset:

UUUUUUUU

Figure 9-5. SSI Data Register (SDR)

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705CT4GRS/D датащи(PDF) 76 Page - NXP Semiconductors