HC705CT4GRSSLASHD datasheet(74/152 Pages) NXP

74 / 152 page

Synchronous Serial Interface (SSI)

General Release Specification

MC68HC705CT4 — Rev. 2.0

Synchronous Serial Interface (SSI)

MOTOROLA

When cleared, this bit configures the SSI to the slave mode and

aborts any transmission in progress. Transfers are initiated by an

external master, which should supply the clock to the SCK pin.

CPOL — Clock Polarity

The clock polarity bit controls the state of the SCK pin between

transmissions.

When this bit is set, pin SCK is high between transmissions.

When this bit is cleared, pin SCK is low between transmissions.

In both cases the data is latched on the rising edge of SCK for serial

input and is valid on the rising edge of SCK for serial output. A reset

sets this bit.

NOTE:

If the SSI is used as a slave, the SCK input pin must be active before

enabling the SSI. For example, if CPOL = 0, SCK must be low; if

CPOL = 1, SCK must be high.

T/R — Transmit/Receive

This bit must be set to allow data to be driven on the SDIO pin

(transmitting). It must be cleared to disable the SDIO drivers when

receiving data. It is cleared by a reset.

SR1 and SR0 — SSI Rate

These bits determine the frequency of SCK when in master mode

(MSTR = 1). They have no effect in slave mode (MSTR = 0).

Table 9-1. SSI Rates

SR1 and SR0

SCK Rates (Hz) at fosc Frequency

32 kHz

64 kHz

128 kHz

256 kHz

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705CT4GRS/D датащи(PDF) 74 Page - NXP Semiconductors