MPC755 datasheet(43/56 Pages) MOTOROLA

43 / 56 page

MPC755 RISC Microprocessor Hardware Specifications, Rev. 6.1

Freescale Semiconductor

System Design Information

Figure 24. JTAG Interface Connection

There is no standardized way to number the COP header shown in Figure 24; consequently, many different pin

numbers have been observed from emulator vendors. Some are numbered top-to-bottom then left-to-right, while

HRESET

From Target

Board Sources

SRESET

VDD_SENSE

5 1

2 kΩ

10 kΩ

OVDD

CHKSTP_IN

TMS

TDO

TDI

TCK

TMS

TDO

TDI

TCK

TRST

(if any)

14 2

Key

QACK

OVDD

10 kΩ

OVDD

TRST

10 kΩ

OVDD

10 kΩ

QACK

CHKSTP_OUT

KEY

No pin

COP Connector

Physical Pin Out

10 kΩ 4

OVDD

2 kΩ 3

0 Ω 5

Notes:

1. RUN/STOP, normally found on pin 5 of the COP header, is not implemented on the MPC755. Connect pin 5 of the COP header

to OVDD with a 10-kΩ pull-up resistor.

2. Key location; pin 14 is not physically present on the COP header.

3. Component not populated. Populate only if debug tool does not drive QACK.

4. Populate only if debug tool uses an open-drain type output and does not actively deassert QACK.

5. If the JTAG interface is implemented, connect HRESET from the target source to TRST from the COP header though an AND

gate to TRST of the part. If the JTAG interface is not implemented, connect HRESET from the target source to TRST of the

part through a 0-Ω isolation reisistor.

HRESET

MPC755 датащи(PDF) 43 Page - Motorola, Inc

MPC755 датащи(HTML) 43 Page - Motorola, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

датащи скачать

ссылки URL