BCM4354 datasheet(23/192 Pages) CYPRESS

23 / 192 page

Power Supplies and Power Management

BCM4354 Data Sheet

BROADCOM CONFIDENTIAL

Broadcom®

October 15, 2014 • 4354-DS109-R

Page 22

Section 2: Power Supplies and Power

Management

Power Supply Topology

One Buck regulator, multiple LDO regulators, and a power management unit (PMU) are integrated into the

BCM4354. All regulators are programmable via the PMU. These blocks simplify power supply design for

Bluetooth, WLAN, and FM functions in embedded designs.

A single VBAT (3.0V to 5.25V DC max.) and VIO supply (1.8V to 3.3V) can be used, with all additional voltages

being provided by the regulators in the BCM4354.

Two control signals, BT_REG_ON and WL_REG_ON, are used to power-up the regulators and take the

respective section out of reset. The CBUCK CLDO and LNLDO power up when any of the reset signals are

deasserted. All regulators are powered down only when both BT_REG_ON and WL_REG_ON are deasserted.

The CLDO and LNLDO may be turned off/on based on the dynamic demands of the digital baseband.

The BCM4354 allows for an extremely low power-consumption mode by completely shutting down the CBUCK,

CLDO, and LNLDO regulators. When in this state, LPLDO1 (which is a low-power linear regulator supplied by

the system VIO supply) provides the BCM4354 with all the voltages it requires, further reducing leakage

currents.

BCM4354 PMU Features

• VBAT to 1.35Vout (600 mA maximum) Core-Buck (CBUCK) switching regulator

• VBAT to 3.3Vout (600 mA maximum) LDO3P3

• VBAT to 3.3Vout (150 mA maximum) LDO3P3_B

• VBAT to 2.5V out (70 mA maximum) BTLDO2P5

• 1.35V to 1.2Vout (150 mA maximum) LNLDO

• 1.35V to 1.2Vout (300 mA maximum) CLDO with bypass mode for deep-sleep

• Additional internal LDOs (not externally accessible)

Figure 3 on page 23 illustrates the typical power topology for the BCM4354. The shaded areas are internal to

the BCM4354.

BCM4354 датащи(PDF) 23 Page - Cypress Semiconductor