AM79C970A datasheet(137/219 Pages) AMD

137 / 219 page

P R E L I M I N A R Y

AMD

137

Am79C970A

CSR82: Bus Activity Timer

Bit

Name

Description

31–16

RES

Reserved locations. Written as

ZEROs and read as undefined.

15–0 DMABAT

Bus Activity Timer. If TIMER

(CSR4, bit 13) is set to ONE, this

allowable time that PCnet-PCI II

controller will take up on the sys-

tem bus during FIFO data trans-

fers. The Bus Activity Timer does

not limit the time on the system

bus during initialization block or

descriptor transfers.

The DMABAT value is inter-

preted as an unsigned number

with a resolution of 0.1

µs. For

instance, a value of 51

µs would

be programmed with a value of

510 (1FEh). A value of ZERO

(the default value) will result in a

single data transfer.

DMABAT starts counting down

when the PCnet-PCI II controller

is granted bus ownership and the

bus is idle. When DMABAT has

counted down to ZERO, the

PCnet-PCI II controller will finish

the current data phase before re-

leasing the bus. Note that be-

cause DMABAT does not run on

the PCI bus interface clock, the

actual time the PCnet-PCI II

controller takes up the bus

might differ by 2 to 3 clock

periods from the value pro-

grammed to DMABAT.

DMABAT should not be enabled

when the PCnet-PCI II controller

is used in a PCI bus application.

The PCI Latency Timer should be

the only entity governing the time

the PCnet-PCI II controller has

control over the bus.

Read/Write

accessible

only

when either the STOP or the

SPND bit is set. Note that the

read operation will yield the value

of the run-time copy of the Bus

Activity Timer and not the regis-

ter that holds the programmed

value. Most read operations will

yield a value of ZERO, because

the run-time counter is only

reloaded with the programmed

value at the beginning of a new

bus mastership period. The Bus

Activity Timer register is cleared

value

0000h

after

H_RESET or S_RESET and is

unaffected

setting

the

STOP bit.

CSR84: DMA Address Register Lower

Bit

Name

Description

31–16

RES

Reserved locations. Written as

ZEROs and read as undefined.

15–0 DMABAL

This register contains the lower

16 bits of the address of system

memory for the current DMA

cycle. The Bus Interface Unit

controls the Address Register

by issuing commands to incre-

ment the memory address for

sequential

operations.

The

DMABAL register is undefined

until the first PCnet-PCI II con-

troller DMA operation.

Read/Write

accessible

only

when either the STOP or the

SPND bit is set. These bits

are unaffected by H_RESET,

S_RESET or by setting the

STOP bit.

CSR85: DMA Address Register Upper

Bit

Name

Description

31–16

RES

Reserved locations. Written as

ZEROs and read as undefined.

15–0 DMABAU

This register contains the upper

16 bits of the address of system

memory for the current DMA cy-

cle. The Bus Interface Unit con-

trols the Address Register by

issuing commands to increment

the memory address for sequen-

tial operations. The DMABAU

first

PCnet-PCI

controller

DMA operation.

Read/Write

accessible

only

when either the STOP or the

SPND bit is set. These bits are

unaffected

H_RESET,

S_RESET or by setting the

STOP bit.

CSR86: Buffer Byte Counter

Bit

Name

Description

31–16

RES

Reserved locations. Written as

ZEROs and read as undefined.

AM79C970A датащи(PDF) 137 Page - Advanced Micro Devices

AM79C970A датащи(HTML) 137 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL