ATmega16U4 datasheet(53/408 Pages) ATMEL

53 / 408 page

7766D–AVR–01/09

ATmega16U4/ATmega32U4

• Bit 5– USBRF: USB Reset Flag

This bit is set if a reset is being caused by a logic one in the JTAG Reset Register selected by

the JTAG instruction AVR_RESET. This bit is reset by a Power-on Reset, or by writing a logic

zero to the flag.

• Bit 4 – JTRF: JTAG Reset Flag

This bit is set if a reset is being caused by a logic one in the JTAG Reset Register selected by

the JTAG instruction AVR_RESET. This bit is reset by a Power-on Reset, or by writing a logic

zero to the flag.

• Bit 3 – WDRF: Watchdog Reset Flag

This bit is set if a Watchdog Reset occurs. The bit is reset by a Power-on Reset, or by writing a

logic zero to the flag.

• Bit 2 – BORF: Brown-out Reset Flag

This bit is set if a Brown-out Reset occurs. The bit is reset by a Power-on Reset, or by writing a

logic zero to the flag.

• Bit 1 – EXTRF: External Reset Flag

This bit is set if an External Reset occurs. The bit is reset by a Power-on Reset, or by writing a

logic zero to the flag.

• Bit 0 – PORF: Power-on Reset Flag

This bit is set if a Power-on Reset occurs. The bit is reset only by writing a logic zero to the flag.

To make use of the Reset Flags to identify a reset condition, the user should read and then

Reset the MCUSR as early as possible in the program. If the register is cleared before another

reset occurs, the source of the reset can be found by examining the Reset Flags.

8.1

Internal Voltage Reference

ATmega16U4/ATmega32U4 features an internal bandgap reference. This reference is used for

Brown-out Detection, and it can be used as an input to the Analog Comparator or the ADC.

8.1.1

Voltage Reference Enable Signals and Start-up Time

The voltage reference has a start-up time that may influence the way it should be used. The

start-up time is given in Table 8-4. To save power, the reference is not always turned on. The

reference is on during the following situations:

When the BOD is enabled (by programming the BODLEVEL [2..0] Fuse).

When the bandgap reference is connected to the Analog Comparator (by setting the

ACBG bit in ACSR).

When the ADC is enabled.

Thus, when the BOD is not enabled, after setting the ACBG bit or enabling the ADC, the user

must always allow the reference to start up before the output from the Analog Comparator or

ATmega16U4 датащи(PDF) 53 Page - ATMEL Corporation