| поискавой системы для электроныых деталей |
|
32186 датащи(PDF) 5 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
32186 датащи(HTML) 5 Page - Renesas Technology Corp |
|
5 / 1032 page ![]() • Guide to Understanding the Register Table (1) Bit number: Indicates a register’s bit number. (2) Register border: The registers enclosed with thick border lines must be accessed in halfwords or words. (3) Status after reset: The initial state of each register after reset is indicated in hexadecimal or binary. (4) Status after reset: The initial state of each register after reset is indicated bitwise. 0: This bit is “0” after reset. 1: This bit is “1” after reset. ?: This bit is undefined after reset. (5) The shaded bits mean that they have no functions assigned. (6) Read conditions: R: This bit can be accessed for read. ?: The value read from this bit is undefined. (Reading this bit has no effect.) 0: The value read from this bit is always “0.” 1: The value read from this bit is always “1.” (7) Write conditions: W: This bit can be accessed for write. N: This bit is write protected. 0: To write to this bit, always write “0.” 1: To write to this bit, always write “1.” –: Writing to this bit has no effect. (It does not matter whether this bit is set to “0” or “1” by writing in software.) Note: Care must be taken when writing to this bit. See Note in each register table. XXXRegister(XXX) <Address: H’XXXX XXXX> b0 123456789 10 11 12 13 14 b15 AAA BBB CCC 000 0 0 0 0 0 0 0 0 0 0 0 0 0 <After reset: H’0000> b Bit name Function R W 0 AAA 0 : • • • • • • • • • bit R W • • • • • • • • • bit 1 : • • • • • • • • • bit 1 BBB 0 : • • • • • • • • • bit R W • • • • • • • • • bit 1 : • • • • • • • • • bit 2 CCC 0 : • • • • • • • • • bit R (Note 1) • • • • • • • • • bit 1 : • • • • • • • • • bit 3–15 No function assigned. Fix to “0.” 0 0 Note 1: Only writing “0” is effective. Writing “1” has no effect, in which case the bit retains the value it had before the write. • Notation of “L” (signals) The symbol “#” suffixed to the pin (or signal) names means that the pins (or signals) are “L.” Before Use (2) (4) (6) (7) (3) (1) (5) |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |