183 / 242 page

Removal and Replacement
TDS 310, TDS 320 & TDS 350 Instruction Manual
825
Bottom of Oscilloscope
To
Acquisition
Board
To
Option
Tied cables if not used
Chassis Bottom
Communications
Cable
Video Cable
Power Cable
Chassis Top
Tied
Cables
Option Board
Communications
Cable
Cable
Clamp
Figure 812:Option 14 Assembly Removal
1. Set the oscilloscope so its bottom is down, with its rear facing you.
2. Unplug the fan power cable from J3 on the Power Supply.
3. Release the two flex locks securing the top of the fan to the fan mount,
then lift the fan out from the top of the chassis (see Figure813).
Fan and Fan Mount