45 / 242 page
TDS 310, TDS 320 & TDS 350 Instruction Manual
27
Using the Probes
The TDS 310, TDS 320, and TDS 350 come with two standard accessory
probes. Use these probes to conduct test signals to the oscilloscope. For
detailed probe specifications and instructions, see the instruction manual
packaged with the probe.
To connect a probe to the oscilloscope, attach the BNC end of the probe to
either the CH 1 or CH 2 input. Be sure to twist the probe end clockwise until
the BNC is fully locked. See Figure 25.
Figure 25:Connecting a Probe
Use the following procedure to compensate the probe every time you set up
your oscilloscope.
1. Attach the probe BNC connector to the CH 1 input and attach the probe
tip tothe PROBE COMP output signal, as shown in Figure 26. Attach the
probe ground clip to the outer ring of the CH 2 BNC.
Connecting a Probe
Compensating a
Probe
Russian ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
