TDS310 datasheet(92/242 Pages) ETC2

92 / 242 page

Controlling Acquisition

Operation

340

Select Acquisition Mode

Press the main menu button Mode. Use the

side menu to select from these modes.

H Press Sample to select sample mode.

H Press Peak Detect to select peak detect mode. Peak detect mode only

operates at SEC/DIV settings of 25 ms or slower.

H Press Envelope to select envelope mode. Use the General Purpose

Knob to adjust the number of envelopes (2, 4, 8, 16, 32, 64, 128, 256, or

R).

H Press Average to select average mode. Use the General Purpose Knob

to adjust the number of acquisitions to average (2, 4, 8, 16, 32, 64, 128,

or 256).

Activate Single Sequence Mode

Press the main menu button Stop

After and then the side menu button Single Acquisition Sequence.

When in single sequence mode, the oscilloscope acquires a single se

quence, display it, and then waits for you to press the RUN/STOP button.

The exact nature of a sequence" depends on the present acquisition mode.

In sample or peak detect mode, a sequence" is a single acquisition. In

envelope or average mode, a sequence" is a number of acquisitions equal

to the number of envelopes or averages.

For example, when both average and single sequence mode are active and

the number of averages is 16, the oscilloscope collects 16 acquisitions,

averages them, displays the resulting waveform, and stops until you press

the RUN/STOP button.

To deactivate single sequence mode, press the side menu button RUN/STOP

button only.

TDS310 датащи(PDF) 92 Page - List of Unclassifed Manufacturers