TPS2480PW datasheet(37/60 Pages) TI2

37 / 60 page

MaxPossible_I=

SHUNT_MAX

SHUNT

MaxPossible_I=0.64

Minimum_LSB=

Max_Expected_I

32767

Minimum_LSB=18.311

-6

Maximum_LSB=

Max_Expected_I

4096

Maximum_LSB=146.520

-6

TPS2480

TPS2481

www.ti.com

SLUS939B – APRIL 2010 – REVISED DECEMBER 2010

Programming The TPS2480/81 Power Measurement Engine

Calibration Register and Scaling

The Calibration Register makes it possible to set the scaling of the Current and Power Registers to whatever

values are most useful for a given application. One strategy may be to set the Calibration Register such that the

largest possible number is generated in the Current Register or Power Register at the expected full-scale point;

this approach yields the highest resolution. The Calibration Register can also be selected to provide values in the

Current and Power Registers that either provide direct decimal equivalents of the values being measured, or

yield a round LSB number. After these choices have been made, the Calibration Register also offers possibilities

for end user system-level calibration, where the value is adjusted slightly to cancel total system error.

Below are two examples for configuring the TPS2480/81 calibration. Both examples are written so the

information directly relates to the calibration setup found in the TPS2480/81EVM software.

Calibration Example 1: Calibrating the TPS2480/81 With No Possibility for Overflow

NOTE

The numbers used in this example are the same used with the TPS2480/81EVM software

as shown in Figure 26. This does not mean the input can go over 26 V!

1. Establish the following parameters:

VBUS_MAX = 32, This does not mean the input can go over 26 V!

VSHUNT_MAX = 0.32

RSHUNT = 0.5

2. Using Equation 30, determine the maximum possible current .

(30)

3. Choose the desired maximum current value. This value is selected based on system expectations.

Max_Expected_I = 0.6

4. Calculate the possible range of current LSBs. To calculate this range, first compute a range of LSBs that is

appropriate for the design. Next, select an LSB within this range. Note that the results will have the most

resolution when the minimum LSB is selected. Typically, an LSB is selected to be the nearest round number

to the minimum LSB value.

(31)

(32)

Choose an LSB in the range: Minimum_LSB<Selected_LSB < Maximum_LSB

Current_LSB = 20 × 10–6

NOTE

This value was selected to be a round number near the Minimum_LSB. This selection

allows for good resolution with a rounded LSB.

Submit Documentation Feedback

Product Folder Link(s): TPS2480 TPS2481

TPS2480PW датащи(PDF) 37 Page - Texas Instruments

TPS2480PW датащи(HTML) 37 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

датащи скачать

ссылки URL