MPC8280 datasheet(181/1386 Pages) FREESCALE

181 / 1386 page

System Interface Unit (SIU)

MPC8280 PowerQUICC II Family Reference Manual, Rev. 1

Freescale Semiconductor

4-9

If the software watchdog timer is programmed to generate an interrupt, it always generates a machine

check interrupt to the core. The external IRQ0 can generate MCP as well. Note that the core takes the

machine check interrupt when MCP is asserted; it takes an external interrupt for any other interrupt

asserted by the interrupt controller. The core will take the critical interrupt when CINT is asserted.

The interrupt controller allows masking of each interrupt source. Multiple events within a CPM sub-block

event are also maskable.

All interrupt sources are prioritized and bits are set in the interrupt pending register (SIPNR). On the

MPC8280, the prioritization of the interrupt sources is flexible in the following two aspects:

•

The relative priority of the FCCs, SCCs, and MCCs can be modified

•

One interrupt source can be assigned the highest priority

When an unmasked interrupt source is pending in the SIPNR, the interrupt controller sends an interrupt

request to the core. When an exception is taken, the interrupt mask bit in the machine state register

(MSR[EE]) is cleared to disable further interrupt requests until software can handle them.

The SIU interrupt vector register (SIVEC) is updated with a 6-bit vector corresponding to the sub-block

with the highest current priority.

4.2.1.1

Machine Check Interrupt

There are several sources for a machine check interrupt (MCP):

•

Software watchdog timer (when programmed to generate an interrupt—See Section 4.1.5,

“Software Watchdog Timer.”)

•IRQ0 signal (when the internal core is enabled)

•

Memory controller for parity/ECC errors (see Section 10.2.6, “Machine Check Interrupt (MCP)

Generation”)

•

PCI bridge

•

Bus monitor time out (on an address only transaction—see Section 4.1.1, “Bus Monitor”)

When the internal core is enabled, these sources cause the interrupt controller to send a MCP to the core.

When the core is disabled the MCP assertion is reflected on IRQ0/NMI_OUT so that an external core can

serve it.

4.2.1.2

INT Interrupt

Besides the MCP sources listed above, other interrupts are taken by the core through the INT interrupt. If

the internal core is disabled, INT is reflected on IRQ7/INT_OUT so that an external core can serve it.

The interrupt controller allows masking of each interrupt source. Multiple events within a CPM sub-block

event are also maskable.

4.2.2

Interrupt Source Priorities

The interrupt controller has 37 interrupt sources that assert one interrupt request to the core. Table 4-2

shows prioritization of all interrupt sources. As described in following sections, flexibility exists in the

MPC8280 датащи(PDF) 181 Page - Freescale Semiconductor, Inc

MPC8280 датащи(HTML) 181 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL