
VT8601 Apollo ProMedia
Revision 1.3 September 8, 1999
-53-
Device 1 Bus 0 Header Registers - PCI-to-AGP Bridge
7HFKQRORJLHV ,QF
:H&
:H&RRQQHFW
QQHFW
Device 1 Offset 18 - Primary Bus Number ......................RW
7-0
Primary Bus Number............................... default = 0
This register is read write, but internally the chip always uses
bus 0 as the primary.
Device 1 Offset 19 - Secondary Bus Number ..................RW
7-0
Secondary Bus Number ........................... default = 0
Note: PCI#2 must use these bits to convert Type 1 to Type 0.
Device 1 Offset 1A - Subordinate Bus Number ..............RW
7-0
Primary Bus Number............................... default = 0
Note: PCI#2 must use these bits to decide if Type 1 to Type 1
command passing is allowed.
Device 1 Offset 1C - I/O Base ...........................................RW
7-4
I/O Base AD[15:12].......................... default = 1111b
3-0
I/O Addressing Capability....................... default = 0
Device 1 Offset 1D - I/O Limit..........................................RW
7-4
I/O Limit AD[15:12] ................................ default = 0
3-0
I/O Addressing Capability....................... default = 0
Device 1 Offset 1F-1E - Secondary Status........................RO
15-0 Reserved
.................................. always reads 0000
Device 1 Offset 21-20 - Memory Base..............................RW
15-4 Memory Base AD[31:20] .................default = 0FFFh
3-0
Reserved
........................................ always reads 0
Device 1 Offset 23-22 - Memory Limit (Inclusive)..........RW
15-4 Memory Limit AD[31:20]........................ default = 0
3-0
Reserved
........................................ always reads 0
Device 1 Offset 25-24 - Prefetchable Memory Base .......RW
15-4 Prefetchable Memory Base AD[31:20].def = 0FFFh
3-0
Reserved
........................................ always reads 0
Device 1 Offset 27-26 - Prefetchable Memory Limit ......RW
15-4 Prefetchable Memory Limit AD[31:20] ...................
.............................................. default = 0
3-0
Reserved
........................................ always reads 0
Device 1 Offset 3F-3E – PCI-to-PCI Bridge Control..... RW
15-4 Reserved
........................................ always reads 0
3
VGA-Present on AGP
0
Forward VGA accesses to PCI Bus ....... default
1
Forward VGA accesses to AGP Bus
Note: VGA addresses are memory A0000-BFFFFh
and I/O addresses 3B0-3BBh, 3C0-3CFh and 3D0-
3DFh (10-bit decode).
"Mono" text mode uses
B0000-B7FFFh and "Color" Text Mode uses B8000-
BFFFFh. Graphics modes use Axxxxh. Mono VGA
uses I/O addresses 3Bx-3Cxh and Color VGA uses
3Cx-3Dxh. If an MDA is present, a VGA will not
use the 3Bxh I/O addresses and B0000-B7FFFh
memory space;
if not, the VGA will use those
addresses to emulate MDA modes.
2
Block / Forward ISA I/O Addresses
0
Forward all I/O accesses to the AGP bus if
they are in the range defined by the I/O Base
and I/O Limit registers (device 1 offset 1C-1D)
.................................................... default
1
Do not forward I/O accesses to the AGP bus
that are in the 100-3FFh address range even if
they are in the range defined by the I/O Base
and I/O Limit registers.
1-0
Reserved
........................................ always reads 0