AM29N323D datasheet(20/48 Pages) AMD

20 / 48 page

August 8, 2002

Am29N323D

Erase Suspend/Erase Resume

Commands

The Erase Suspend command, B0h, allows the sys-

tem to interrupt a sector erase operation and then read

data from, or program data to, any sector not selected

for erasure. The bank address is required when writing

this command. This command is valid only during the

sector erase operation, including the minimum 50 µs

time-out period during the sector erase command se-

quence. The Erase Suspend command is ignored if

written during the chip erase operation or Embedded

Program algorithm.

When the Erase Suspend command is written during

the sector erase operation, the device requires a

maximum of 20 µs to suspend the erase operation.

However, when the Erase Suspend command is

written during the sector erase time-out, the device

immediately terminates the time-out period and sus-

pends the erase operation.

After the erase operation has been suspended, the

bank enters the erase-suspend-read mode. The

system can read data from or program data to any

sector not selected for erasure. (The device “erase

suspends” all sectors selected for erasure.) Reading at

any address within erase-suspended sectors produces

status information on DQ7–DQ0. The system can use

DQ7, or DQ6 and DQ2 together, to determine if a

sector is actively erasing or is erase-suspended. Refer

to the Write Operation Status section for information on

these status bits.

After an erase-suspended program operation is com-

plete, the bank returns to the erase-suspend-read

mode. The system can determine the status of the

program operation using the DQ7 or DQ6 status bits,

just as in the standard program operation. Refer to the

Write Operation Status section for more information.

In the erase-suspend-read mode, the system can also

issue the autoselect command sequence. Refer to the

Autoselect Functions and Autoselect Command

Sequence sections for details.

To resume the sector erase operation, the system must

write the Erase Resume command. The bank address

of the erase-suspended bank is required when writing

this command. Further writes of the Resume command

are ignored. Another Erase Suspend command can be

written after the chip has resumed erasing.

Figure 2.

Erase Operation

START

Write Erase

Command Sequence

Data Poll

from System

Data = FFh?

Yes

Erasure Completed

Embedded

Erase

algorithm

in progress

Notes:

1. See Table 4 for erase command sequence.

2. See the section on DQ3 for information on the sector

erase timer.

AM29N323D датащи(PDF) 20 Page - Advanced Micro Devices

AM29N323D датащи(HTML) 20 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

датащи скачать

ссылки URL