SPEAR600 datasheet(75/97 Pages) STMICROELECTRONICS

номер детали	SPEAR600

подробное описание детали	Embedded MPU with dual ARM926 core, flexible memory support, powerful connectivity features and programmable LCD interface

PDF	97 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

75 / 97 page

SPEAr600

Timing characteristics

Doc ID 16259 Rev 3

75/97

Note:

The timings shown in Figure 21 depend on the programmed values of TSCLHigh and

TSCLLow: so, the values present in Table 45 to Table 47 have been calculated using the

minimum programmable values of:

IC_HS_SCL_HCNT=19 and IC_HS_SCL_LCNT=53 registers (for High-Speed mode)

IC_FS_SCL_HCNT=99 and IC_FS_SCL_LCNT=215 registers (for Fast-Speed mode)

IC_SS_SCL_HCNT=664 and IC_SS_SCL_LCNT=780 registers (for Standard-Speed

mode).

These minimum values depend on the AHB clock frequency, which is 166 MHz.

Note:

A device may internally require a hold time of at least 300 ns for the SDA signal (referred to

the VIHmin of the SCL signal) to bridge the undefined region of the falling edge of SCL

(Please refer to the I2C Bus Specification v3-0 Jun 2007). However, the SDA data hold time

in the I2C controller of SPEAr600 is one-clock cycle based (7 ns with the HCLK clock at 166

MHz). This time may be insufficient for some slave devices. A few slave devices may not

receive the valid address due to the lack of SDA hold time and will not acknowledge even if

the address is valid. If the SDA data hold time is insufficient, an error may occur.

Workaround: If a device needs more SDA data hold time than one clock cycle, an RC delay

circuit is needed on the SDA line as illustrated in Figure 22

Figure 22.

RC delay circuit

For example, R=K and C=200 pF.

SDA from SPEAr pad

SDA to Device

SPEAR600 датащи(PDF) 75 Page - STMicroelectronics