| поискавой системы для электроныых деталей |
|
ST72344K2 датащи(PDF) 179 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST72344K2 датащи(HTML) 179 Page - STMicroelectronics |
|
179 / 247 page ![]() ST72344xx, ST2345xx On-chip peripherals Doc ID 12321 Rev 6 179/247 Bit 1= ITWE3 Interrupt enable on write to Slave 3 This bit is set and cleared by software. It is also cleared by hardware when the interface is disabled. 0: Interrupt after write to Slave 3 disabled 1: Interrupt after write to Slave 3 enabled Bit 0 = ITWE1/2 Interrupt enable on write to Slave 1 or 2 This bit is set and cleared by software. It is also cleared by hardware when the interface is disabled software. It is also cleared by hardware when the interface is disabled. 0: Interrupt after write to Slave 1 or 2 disabled 1: Interrupt after write to Slave 1 or 2 enabled I2C control register 2 (I2C3SCR2) Reset value: 0000 0000 (00h) Bits 7:5 = Reserved, must be kept at 0. Bit 4 = WP2 Write Protect enable for Slave 2 This bit is set and cleared by software. It is also cleared by hardware when the interface is disabled (PE=0) 0: Write access to Slave 2 RAM buffer enabled 1: Write access to Slave 2 RAM buffer disabled Bit 3 = WP1 Write Protect enable for Slave 1 This bit is set and cleared by software. It is also cleared by hardware when the interface is disabled (PE=0). 0: Write access to Slave 1 RAM buffer enabled 1: Write access to Slave 1 RAM buffer disabled Note: (Applicable for both WP2/ WP1) Only write operations are disabled/enabled. Read operations are not affected. If a write operation is attempted, the slave address is acknowledged, the current address register is overwritten, data is also acknowledged but it is not written to the RAM. Both the current address and byte count registers are incremented as in normal operation. No interrupt generated if slave is write protected BusyW will not be set if slave is write protected Bit 2 = PE Peripheral enable This bit is set and cleared by software. 0: Peripheral disabled 1: Slave capability enabled Note: To enable the I2C interface, write the CR register TWICE with PE=1, as the first write only activates the interface (only PE is set). 7 0 0 0 0 WP2 WP1 PE BusyW B/W Read / Write |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |