| поискавой системы для электроныых деталей |
|
PC87365 датащи(PDF) 114 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
PC87365 датащи(HTML) 114 Page - National Semiconductor (TI) |
|
114 / 215 page ![]() 3.0 System Wake-Up Control (SWC) (Continued) 114 www.national.com 3.4.32 Standby GPIO Pin Configuration Register (SBGPCFG) This is a group of 12 configuration registers. Eight are identical for GPIOE and GPIE, two are identical for GPOS and two are identical for GPIS. Each GPIOE/GPIE register is associated with one GPIOE/GPIE pin, and each GPOS and GPIS reg- ister is associated with one GPOS or GPIS pin. The entire set is mapped to the same address. The mapping scheme is based on the Standby GPIO Pin Select (SBGPSEL) register that functions as an index register and the specific Standby GPIO Pin Configuration register that reflects the configuration of the currently selected pin. Bits 0-3 are applicable only for pins GPIOE0-5 and GPOS0,1. Bits 4-6 are applicable for all GPIOE/GPIE pins. Location: Bank 3, Offset 14h Type: R/W (bit 3 is set only) For GPIOE and GPIE: For GPOS: For GPIS: Bit 76543210 Name Reserved Event Debounce Enable Event Polarity Event Type Lock Pull-Up Control Output Type Output Enable Reset 01000100 Bit 76543210 Name Reserved Lock Pull-Up Control Output Type Output Enable Reset 00000101 Bit 76543210 Name Reserved Reset 00000000 Bit Description 7 Reserved. (For GPOS and GPIS, bits 7-4 and 7-0 are reserved, respectively). 6 Event Debounce Enable. 0: Disabled 1: Enabled (default) 5 Event Polarity. This bit defines the polarity of the signal that causes a detection of an event from the corresponding GPIO pin. 0: Falling edge input (default) 1: Rising edge input 4 Event Type. This bit defines the signal type that causes a detection of an event from the corresponding GPIO pin. 0: Edge input (default) 1: Reserved 3 Lock. This bit locks bits 2-0 of this register. These bits are associated with the GPIO pin currently selected by the SBGPSEL register. Once this bit is set to 1 by software, it can only be cleared to 0 by VSB power-up reset. 0: No effect (default at VSB power-up reset) 1: Direction, output type, pull-up and output value locked |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |