LPC1102 datasheet(8/38 Pages) NXP

8 / 38 page

LPC1102

All information provided in this document is subject to legal disclaimers.

Objective data sheet

Rev. 00 — 23 June 2010

8 of 38

NXP Semiconductors

LPC1102

32-bit ARM Cortex-M0 microcontroller

• Four programmable interrupt priority levels, with hardware priority level masking.

• Relocatable vector table.

• Software interrupt generation.

7.5.2 Interrupt sources

Each peripheral device has one interrupt line connected to the NVIC but may have several

interrupt flags. Individual interrupt flags may also represent more than one interrupt

source.

Any GPIO pin (total of up to 11 pins) regardless of the selected function, can be

programmed to generate an interrupt on a level, or rising edge or falling edge, or both.

7.6 IOCONFIG block

The IOCONFIG block allows selected pins of the microcontroller to have more than one

function. Configuration registers control the multiplexers to allow connection between the

pin and the on-chip peripherals.

Peripherals should be connected to the appropriate pins prior to being activated and prior

to any related interrupt(s) being enabled. Activity of any enabled peripheral function that is

not mapped to a related pin should be considered undefined.

7.7 Fast general purpose parallel I/O

Device pins that are not connected to a specific peripheral function are controlled by the

GPIO registers. Pins may be dynamically configured as inputs or outputs. Multiple outputs

can be set or cleared in one write operation.

LPC1102 use accelerated GPIO functions:

• GPIO registers are a dedicated AHB peripheral so that the fastest possible I/O timing

can be achieved.

• Entire port value can be written in one instruction.

Additionally, any GPIO pin (total of 11 pins) providing a digital function can be

programmed to generate an interrupt on a level, a rising or falling edge, or both.

7.7.1 Features

• Bit level port registers allow a single instruction to set or clear any number of bits in

one write operation.

• Direction control of individual bits.

• All I/O default to inputs with pull-ups enabled after reset.

• Pull-up/pull-down resistor configuration can be programmed through the IOCONFIG

block for each GPIO pin.

7.8 UART

The LPC1102 contains one UART.

Support for RS-485/9-bit mode allows both software address detection and automatic

address detection using 9-bit mode.

LPC1102 датащи(PDF) 8 Page - NXP Semiconductors

LPC1102 датащи(HTML) 8 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

датащи скачать

ссылки URL