AS8218 datasheet(31/123 Pages) AMSCO

номер детали	AS8218

подробное описание детали	Highly Integrated Single Phase 2 Current Energy Metering Integrated Circuits

PDF	123 Pages

Scroll/Zoom	100%

производитель	AMSCO [ams AG]

домашняя страница	http://www.ams.com

Logo

31 / 123 page

Data Sheet AS8218 / AS8228

Revision 3.0, 31-May-06

Page 31 of 123

LED Output Timing

The pulses on the LED output indicate the amount of energy that has been consumed over a certain period of

time. Each pulse has an equivalent that can be set in the SREG/mconst register exactly. The unit is impulses

per kWh (i/kWh).

This output may be used for calibration.

The polarity of the LED pulses may be selected via the ledpol bit in the SREG/Select Register for either

positive or negative going pulses.

Timing Diagram

Timing Parameters

Parameter

Symbol

Min

Typ

Max

Unit

Notes

Pulse width

50% duty cycle is enabled when the LED

period is less than 160ms. For mconst=0,

t1 will be 17.9µs.

One register block contains the data for the Meter Data Register (MDR) and the Settings Register (SREG),

hence only one interface to the MCU is required.

Meter Data Register (MDR)

The meter data register is updated after ‘nsamp’ samples. Then an interrupt is issued to the MCU, which may

take the energy data and process them further on. When an interrupt is generated the ‘ack’ bit in the

SREG/Status register is set. If the MCU takes the data, it has to reset the ‘ack’ bit.

If the ‘ack’ bit has not been reset by the MCU when a new set of data is ready, the previous np value will be

added to the new one.

In any case the dai flag in the SREG/Status register must be reset in order to clear the interrupt.

AS8218 датащи(PDF) 31 Page - ams AG