7906 datasheet(95/531 Pages) RENESAS

95 / 531 page

7906 Group User’s Manual Rev.2.0

INTERRUPTS

6-16

6.8 Return from interrupt routine

When the RTI instruction is executed at the end of the interrupt routine, the contents of the program bank

area just before the INTACK sequence are automatically pulled. After this, the control returns to the original

routine. And then, the suspended processing, which was in progress before acceptance of the interrupt

request, is resumed.

Before the RTI instruction is executed, registers which were pushed by software in the interrupt routine must

be pulled in the same data length and register length as those in pushing, using the PUL instruction, etc.

6.9 Multiple interrupts

Just after a branch is made to an interrupt routine, the following occur:

•Interrupt disable flag (I) = “1” (Interrupts are disabled.)

•Interrupt request bit of accepted interrupt = “0”

•Processor interrupt priority level (IPL) = Interrupt priority level of accepted interrupt

Accordingly, as long as the IPL remains unchanged, an interrupt request, whose priority level is higher than

that of the interrupt which is in progress, can be accepted by clearing the interrupt disable flag (I) to “0” in

an interrupt routine. In this way, multiple interrupts are processed.

Figure 6.9.1 shows the processing for multiple interrupts.

An interrupt request which has not been accepted because its priority level is lower is retained. When the

RTI instruction is executed, the interrupt priority level of the routine which was in progress just before

acceptance of an interrupt request is pulled into the IPL. Therefore, if the following relationship is satisfied

when interrupt priority level detection is performed next, the retained interrupt request will be accepted.

Retained interrupt request’s priority level > Processor interrupt priority level (IPL)

Note: When any of the following interrupt requests is generated while an interrupt routine is in progress, this

interrupt request is accepted at once: zero division, watchdog timer, and address matching detection.

6.8 Return from interrupt routine, 6.9 Multiple interrupts

7906 датащи(PDF) 95 Page - Renesas Technology Corp