CMV300 datasheet(20/56 Pages) AMSOSRAM

20 / 56 page

Reference:CMV300-datasheet-v2.11

CMV300 Datasheet

Page 18 of 54

SPI_EN

SPI_IN

SPI_CLK

’1'

½ CLK

1 CLK

FIGURE 8: SPI WRITE TIMING FOR 2 REGISTERS IN BURST

3.9.2 SPI READ

The timing to read data from the registers over the SPI interface can be found below.

SPI_EN

SPI_IN

SPI_CLK

’0'

SPI_OUT

½ CLK

1 CLK

FIGURE 9: SPI READ TIMING

To indicate a read action over the SPI interface, the control bit on the SPI_IN pin is made ‘0’. The address of the register

being read out is sent immediately after this control bit (MSB first). After the LSB of the address bits, the data is launched

on the SPI_OUT pin on the falling edge of the SPI_CLK. This means that the data should be sampled by the receiving

system on the rising edge of the SPI_CLK. The data comes over the SPI_OUT with MSB first. When reading out the

temperature sensor over the SPI, addresses 78 and 79 should be read out in burst mode (keep SPI_EN high).

When SPI_EN is low, SPI_OUT will be (pulled) low.

3.10 REQUESTING A FRAME

After starting up the sensor (see section 3.7), a number of frames can be requested by sending a FRAME_REQ pulse.

The number of frames can be set by programming the appropriate register (addresses 55 and 56). The default number

of frames to be grabbed is 1.

In internal-exposure-time mode, the exposure time will start after this FRAME_REQ pulse. In the external-exposure-

time mode, the read-out will start after the FRAME_REQ pulse. Both modes are explained into detail in the sections

below.

3.10.1 INTERNAL EXPOSURE CONTROL

In this mode, the exposure time is set by programming the appropriate registers (address 42-44) of the CMV300.

After the high state of the FRAME_REQ pulse is detected, the exposure time will start immediately. When the exposure

time ends (as programmed in the registers), the pixels are being sampled and prepared for read-out. This sequence is

called the frame overhead time (FOT). After the FOT, the frame is read-out automatically. If more than one frame is

requested, the exposure of the next frame starts already during the read-out of the previous one (pipeline mode). See

the diagram below for more details.

FRAME_REQ

Exposure time

Frame1_cycle

FOT

Read-out time

Exposure time

Frame2_cycle

FOT

Read-out time

FIGURE 10: REQUEST FOR 2 FRAMES IN INTERNAL- EXPOSURE-TIME MODE

When the exposure time is shorter than the read-out time, the FOT and read-out of the next frame will start immediately

after the read-out of the previous frame.

CMV300 датащи(PDF) 20 Page - ams-OSRAM AG

CMV300 датащи(HTML) 20 Page - ams-OSRAM AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

датащи скачать

ссылки URL