

2005-2020 Microchip Technology Inc.

DS20005045D-page 17

SST25VF080B

5.0

ELECTRICAL SPECIFICATIONS

Absolute Maximum Ratings (†)

Temperature under bias ..........................................................................................................................-55°C to +125°C

Storage temperature ...............................................................................................................................-65°C to +150°C

DC voltage on any pin to ground potential...........................................................................................-0.5V to VDD+0.5V

Transient voltage (<20 ns) on any pin to ground potential...................................................................-2.0V to VDD+2.0V

Package power dissipation capability (TA = 25°C)....................................................................................................1.0W

Surface mount solder reflow temperature.......................................................................................260°C for 10 seconds

Output short circuit current(1) ..................................................................................................................................50 mA

5.1

Power-Up Specifications

All functionalities and DC specifications are specified

for a VDD ramp rate of greater than 1V per 100 ms

(0V to 3.0V in less than 300 ms). See Table 5-3 and

Figure 5-1 for more information.

† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the

device. This is a stress rating only and functional operation of the device at those or any other conditions above those

indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for

extended periods may affect device reliability.

Note 1: Output shorted for no more than one second. No more than one output shorted at a time.

TABLE 5-1:

OPERATING RANGE

Range

Ambient Temp.

VDD

Commercial

0°C to +70°C

2.7V-3.6V

Industrial

-40°C to +85°C

TABLE 5-2:

AC CONDITIONS OF TEST(1)

Input Rise/Fall Time

Output Load

5 ns

CL = 30 pF

Note 1: See Figure 5-2 and Figure 5-3.

TABLE 5-3:

RECOMMENDED SYSTEM

POWER-UP/POWER-DOWN

TIMINGS

Symbol

Parameter

Min Units

TPU-READ(1)

VDD Minimum to

Read Operation

100

µs

TPU-WRITE(1) VDD Minimum to

Write Operation

100

µs

Note 1: This parameter is measured only for initial

qualification and after a design or process

change that could affect this parameter.