CF52012 datasheet(28/48 Pages) INTEL

28 / 48 page

1.6.3.1. Read Non-Volatile Configuration Register Operation (B5h)

To execute a read non-volatile configuration register, drive the nCS low. For extended

SPI protocol, the operation code is input on DATA0, and output on DATA1. You can

terminate the operation by driving the nCS low at any time during data output. The

nonvolatile configuration register can be read continuously. After all 16 bits of the

Figure 4.

Read Non-Volatile Configuration Register Operation Timing Diagram

7 6 5 4 3 2 1 0 15 14 13 12 11 10 9 8

0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Operation Code (B5h)

High Impedance

NVCR Out

LS Byte

MS Byte

nCS

DCLK

DATA0

DATA

1.6.3.2. Write Non-Volatile Configuration Register Operation (B1h)

You need to write the non-volatile configuration registers for EPCQ devices for

different configuration schemes. If you are using the .jic file, the Intel Quartus Prime

programmer sets the number of dummy clock cycles and address bytes accordingly. If

you are using an external programmer tools, you must set the non-volatile

configuration registers.

To set the non-volatile configuration register, follow these steps:

1. Execute the write enable operation.

2. Execute the write non-volatile configuration register operation.

3. Set the 16-bit register value.

Set the 16-bit register value as b'1110 111y xxxx 1111 where y is the address

byte (0 for 4-byte addressing and 1 for 3-byte addressing) and xxxx is the dummy

clock value. When the xxxx value is from 0001 to 1110, the dummy clock value is

from 1 to 14. When xxxx is 0000 or 1111, the dummy clock value is at the default

value, which is 8 for standard fast read (AS x1) mode and 10 for extended quad input

fast read (AS x4 mode).

1. Quad-Serial Configuration (EPCQ) Devices Datasheet

CF52012 | 2018.06.01

Quad-Serial Configuration (EPCQ) Devices Datasheet

CF52012 датащи(PDF) 28 Page - Intel Corporation