| поискавой системы для электроныых деталей |
|
HAL855 датащи(PDF) 9 Page - Micronas |
|
|
|||||||||||||||||||||||||||||
HAL855 датащи(HTML) 9 Page - Micronas |
|
9 / 102 page ![]() APPLICATION NOTE HAL8xy, HAL100x Programmer Board Micronas Sept. 19, 2013; APN000046_03EN 9 2.4. The COM Port Parameters The basic parameters for the setup of the serial communication are described in Table 2–1. 2.5. Connectors Up to four sensors can be connected to the programmer board V 5.1. For this purpose, two 6-pin connectors, HAL 1/2 and HAL 3/4, are supplied. Note: In case of HAL 810, HAL 856 and HAL 1000 only one sensor can be connected to the board. These sensors do not support the required multi-programming function. Alternatively, one Hall sensor can be inserted in the three-pin socket HAL beneath the connector HAL 1/2. The pins of this socket are connected parallel to pins 1, 3, and 5 of the connector HAL 1/2. The male plug (Amp 215083) corresponding to the red connectors HAL 1/2 and HAL 3/ 4 can be ordered from Bürklin with the order no. 58F462. Fig. 2–1: Interface connector HAL 1/2 (HAL 3/4). Table 2–1: COM port parameters Parameter Value Remarks Baud rate 9600 57600 Jumper ’BaudRate’ set Jumper ’BaudRate’ open Data bits 8 Stop bits 1 Parity EVEN Flow control NONE 1 2 3 4 5 6 |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |