HAL855 datasheet(75/102 Pages) MICRONAS

75 / 102 page

APPLICATION NOTE

HAL8xy, HAL100x

Programmer Board

Micronas

Sept. 19, 2013; APN000046_03EN

6.3.6.

Programming Information

If the content of any register is to be changed, the desired value must first be written

into the corresponding RAM register. Before reading out the RAM register again, the

Permanently storing a value in the EEPROM is done by first sending an ERASE com-

mand followed by sending a PROM command and a read command. The address

within the ERASE and PROM commands is not important. ERASE and PROM act on

all registers in parallel.

If all HAL855 registers are to be changed, all writing commands can be sent one after

the other, followed by sending one ERASE and PROM command at the end.

During all communication sequences, the customer has to check if the communication

with the sensor was successful. This means that the acknowledge and the parity bits

sent by the sensor have to be checked by the customer. If the Micronas programmer

board is used, the customer has to check the error flags sent from the programmer

board. It is recommended to use the programmer board version 5.1.

Note: For production and qualification tests, it is mandatory to set the Lock bit after

final adjustment and programming of HAL855. The Lock function is active after

the next power-up of the sensor.

The success of the Lock process should be checked by reading at least one

sensor register after locking and/or by an analog check of the sensor’s output

signal.

Electrostatic Discharges (ESD) may disturb the programming pulses. Please

take precautions against ESD.

HAL855 датащи(PDF) 75 Page - Micronas