KAF-8300 datasheet(10/28 Pages) ONSEMI

10 / 28 page

KAF−8300

www.onsemi.com

Table 6. SPECIFICATIONS (continued)

Description

Verification

Plan

Notes

Unit

Max.

Nom.

Min.

Symbol

MONOCHROME DEVICES

Sensitivity − Monochrome

Resp

465

−

655

Die18

Quantum Efficiency

Microlens, Clear Glass (540 nm)

Microlens, No Glass (540 nm)

Microlens, AR Glass (540 nm)

No Microlens, Clear G. (560 nm)

−

Design19

1. Increasing output load currents to improve bandwidth will decrease these values.

2. Specified from 12

°C to 60°C.

3. Saturation signal level achieved while meeting Le specification. Specified from 0

°C to 40°C.

4. Operating temperature = 60

°C.

5. Worst case deviation, (from 10 mV to VSAT min), relative to a linear fit applied between 0 and 500 mV exposure.

6. Operating temperature = 25

°C.

7. Peak to peak non-uniformity test based on an average of 185

× 185 blocks.

8. Average non-illuminated signal with respect to over clocked horizontal register signal.

9. Absolute difference between the maximum and minimum average signal levels of 185

× 185 blocks within the sensor.

10. Dark rms deviation of a multi-sampled pixel as measured using the KAF−8300 Evaluation Board.

11. 20Log (VSAT / N).

12. Gradual variations in hue (red with respect to green pixels and blue with respect to green pixels) in regions of interest of 185

× 185 blocks.

13. Measured per transfer at 80% of VSAT.

14. ESAT equals the exposure required to achieve saturation. X_b represents the number of ESAT exposures the sensor can tolerate before

failure. X_b characterized at 25

°C.

15. Video level DC offset with respect to ground at clamp position. Refer to Figure 17.

16. Last stage only. CLOAD = 10 pF. Then f−3dB = (1 / (2p ⋅ ROUT ⋅ CLOAD)).

17. Amount of artificial signal due to H1 coupling.

18. A parameter that is measured on every sensor during production testing.

19. A parameter that is quantified during the design verification activity.

20. Calculated value subtracting the noise contribution from the KAF−8300 Evaluation Board.

21. Process optimization has effectively eliminated vertical striations.

22. CTE = 1 − CTI. Where CTE is charge transfer efficiency and CTI is charge transfer inefficiency. CTI is the measured value.

KAF-8300 датащи(PDF) 10 Page - ON Semiconductor

KAF-8300 датащи(HTML) 10 Page - ON Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

датащи скачать

ссылки URL