DSM2180F3 datasheet(11/63 Pages) STMICROELECTRONICS

11 / 63 page

Obsolete

Product(s)

- Obsolete

Product(s)

11/63

DSM2180F3

TYPICAL CONNECTIONS

Figure 6 shows a typical connection scheme.

Many connection possibilities exist since most

DSM pins are multipurpose. The scheme illustrat-

ed is ideal for a design that needs fast JTAG ISP,

Eight additional general I/O with PLD capability,

access to Flash memory as Byte DMA or as Data

Overlay memory, and the DSP uses Power Down

mode. If your design needs more I/O, or Byte DMA

access to Flash memory is all that is needed (no

Data Overlay), or lowest power consumption is not

an issue, then consider the following options.

Port C JTAG: Figure 6 shows all six JTAG sig-

nals in use full time (not multiplexed with I/0). Us-

ing six-pin JTAG can reduce ISP time by as much

as 30% compared to four-pin JTAG. Alternatively,

four-pin JTAG (TMS, TCK, TDI, TDO) can be used

if more general I/O pins are needed and the few

extra seconds of programming time is not crucial,

freeing up pins PC3 and PC4. Other JTAG options

include mutiplexing JTAG pins with general I/O

(see “Programming In-Circuit using JTAG ISP” on

page 41 and Application Note AN1153) or not us-

ing JTAG at all. If no JTAG is used, the DSM de-

vice has to be programmed on a conventional

programmer before it is installed on the circuit

board. Using no JTAG makes more I/O available.

Pin PD1. If Flash memory will be accessed only

using Byte DMA mode in your design, and no ex-

ternal Data Overlay memory accesses are used,

then pin PD1 can be used for other purposes

(MCUI/O, common CPLD clock input, external

chip select, or PLD input)

Pin PD2. If the DSP will not use Power Down

mode, then PD2 can be used for other purposes

(MCUI/O, external chip select, PLD input)

Pins PC2 and PC7. In Figure 6, these two pins

are used as dedicated address inputs connected

to DSP address outputs. This will route DSP ad-

dress signals A16 and A17 directly into the DPLD.

Be aware that any free pin on Port B, Port C, or

Port D may be used for DSP address inputs, it

does not have to be pins PC2 and PC7.

Pin PB0. This pin is shown as a chip select for an

external peripheral device such as a 16450 or

16550 UART. Equivalently, any free pin on Ports

B, C, or D may be used for this.

DSM2180F3 датащи(PDF) 11 Page - STMicroelectronics

DSM2180F3 датащи(HTML) 11 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

датащи скачать

ссылки URL