ATmega328P datasheet(94/345 Pages) ATMEL

94 / 345 page

7810A–AVR–11/09

ATmega328P [Preliminary]

A frequency (with 50% duty cycle) waveform output in fast PWM mode can be achieved by set-

ting OC0x to toggle its logical level on each compare match (COM0x1:0 = 1). The waveform

generated will have a maximum frequency of f

OC0 = fclk_I/O/2 when OCR0A is set to zero. This

feature is similar to the OC0A toggle in CTC mode, except the double buffer feature of the Out-

put Compare unit is enabled in the fast PWM mode.

14.7.4

Phase Correct PWM Mode

The phase correct PWM mode (WGM02:0 = 1 or 5) provides a high resolution phase correct

PWM waveform generation option. The phase correct PWM mode is based on a dual-slope

operation. The counter counts repeatedly from BOTTOM to TOP and then from TOP to BOT-

TOM. TOP is defined as 0xFF when WGM2:0 = 1, and OCR0A when WGM2:0 = 5. In

non-inverting Compare Output mode, the Output Compare (OC0x) is cleared on the compare

match between TCNT0 and OCR0x while upcounting, and set on the compare match while

downcounting. In inverting Output Compare mode, the operation is inverted. The dual-slope

operation has lower maximum operation frequency than single slope operation. However, due to

the symmetric feature of the dual-slope PWM modes, these modes are preferred for motor con-

trol applications.

In phase correct PWM mode the counter is incremented until the counter value matches TOP.

When the counter reaches TOP, it changes the count direction. The TCNT0 value will be equal

to TOP for one timer clock cycle. The timing diagram for the phase correct PWM mode is shown

on Figure 14-7. The TCNT0 value is in the timing diagram shown as a histogram for illustrating

the dual-slope operation. The diagram includes non-inverted and inverted PWM outputs. The

small horizontal line marks on the TCNT0 slopes represent compare matches between OCR0x

and TCNT0.

Figure 14-7. Phase Correct PWM Mode, Timing Diagram

The Timer/Counter Overflow Flag (TOV0) is set each time the counter reaches BOTTOM. The

Interrupt Flag can be used to generate an interrupt each time the counter reaches the BOTTOM

value.

TOVn Interrupt Flag Set

OCnx Interrupt Flag Set

TCNTn

Period

OCnx

(COMnx1:0 = 2)

(COMnx1:0 = 3)

OCRnx Update

ATmega328P датащи(PDF) 94 Page - ATMEL Corporation