| поискавой системы для электроныых деталей |
|
TMS320VC5504 датащи(PDF) 22 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
TMS320VC5504 датащи(HTML) 22 Page - Texas Instruments |
|
22 / 128 page ![]() TMS320VC5504 Fixed-Point Digital Signal Processor SPRS609A – JUNE 2009 – REVISED JULY 2009 www.ti.com Table 3-6. Real-Time Clock (RTC) Terminal Functions SIGNAL TYPE(1) OTHER(2)(3) DESCRIPTION NAME NO. Real-time clock oscillator output. This pin operates at the RTC core voltage, CVDDRTC, and supports a 32.768-kHz crystal. If the RTC oscillator is not used, it can be disabled by connecting RTC_XI to – CVDDRTC and RTC_XO to ground (VSS). A voltage must still be applied to CVDDRTC RTC_XO A9 I CVDDRTC (see Section 5.2, Recommended Operating Conditions). Note: When RTC oscillator is disabled, the RTC registers (I/O address range 1900h – 197Fh) are not accessible. Real-time clock oscillator input. If the RTC oscillator is not used, it can be disabled by connecting RTC_XI to CVDDRTC and RTC_XO to ground (VSS). A voltage must still be applied to CVDDRTC – RTC_XI B9 I (see Section 5.2, Recommended Operating Conditions). CVDDRTC Note: When RTC oscillator is disabled, the RTC registers (I/O address range 1900h – 197Fh) are not accessible. Real-time clock output pin. This pin operates at DVDDRTC voltage. The – RTC_CLKOUT pin is enabled/disabled through the RTCCLKOUTEN bit in the RTC RTC_CLKOUT D8 O/Z DVDDRTC Power Management Register (RTCPMGT). At reset, the RTC_CLKOUT pin is disabled (high-impedance [Hi-Z]). The pin is used to WAKEUP the core from idle condition. This pin defaults to an – WAKEUP E8 I/O/Z input at CVDDRTC powerup, but can also be configured as an active-low open-drain DVDDRTC output signal to wakeup an external device from an RTC alarm. (1) I = Input, O = Output, Z = High impedance, S = Supply voltage, GND = Ground, A = Analog signal (2) IPD = Internal pulldown, IPU = Internal pullup. For more detailed information on pullup/pulldown resistors and situations where external pullup/pulldown resistors are required, see Section 4.8.1, Pullup/Pulldown Resistors. (3) Specifies the operating I/O supply voltage for each signal Device Overview 22 Submit Documentation Feedback |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |