STLC1502 datasheet(48/81 Pages) STMICROELECTRONICS

номер детали	STLC1502

подробное описание детали	VOICE OVER IP PROCESSOR

PDF	81 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

48 / 81 page

STLC1502

48/81

Error Cases

•

BERR: Detection of a Stop or a Start condition during a byte transfer. In this case, the EVF and

BERR bits are set by hardware with an interrupt if ITE is set.

•

AF: Detection of a non-acknowledge bit. In this case, the EVF and AF bits are set by hardware with

an interrupt if the ITE bit is set. To resume, set the START or STOP bit.

•

ARLO: Detection of an arbitration lost condition. In this case the ARLO bit is set by hardware (with an

interrupt if the ITE bit is set and the interface goes automatically back to slave mode (the M/SL bit is

cleared).

Note: In all these cases, the SCL line is not held low; however, the SDA line can remain low due to possi-

ble «0» bits transmitted last. It is then necessary to release both lines by software.

Event Flags and interrupt generation diagram

7.6.4 I2C registers map [0X0C300000]

The base address of the Remap & Pause register is 0x0C300000.

The offset of any particular register from the base address is the following.

Address

Name

R/W

Notes

I2C_regBase+ 0x20

I2CCR

R/W

I2C configuration register

I2C_regBase+ 0x24

I2CSR1

R/W

I2C status register 1

I2C_regBase+ 0x28

I2CSR2

R/W

I2C status register 2.

STLC1502 датащи(PDF) 48 Page - STMicroelectronics