| поискавой системы для электроныых деталей |
|
LP5562 датащи(PDF) 40 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
LP5562 датащи(HTML) 40 Page - Texas Instruments |
|
40 / 52 page ![]() LP5562 MCU 1 PF CIN SCL SDA CLK_32K ADDR_SEL0 ADDR_SEL1 EN/VCC VDD GND R G B RGB LED 0...25.5 mA/LED WLED VDD 40 LP5562 SNVS820B – APRIL 2013 – REVISED DECEMBER 2016 www.ti.com Product Folder Links: LP5562 Submit Documentation Feedback Copyright © 2013–2016, Texas Instruments Incorporated 8 Application and Implementation NOTE Information in the following applications sections is not part of the TI component specification, and TI does not warrant its accuracy or completeness. TI’s customers are responsible for determining suitability of components for their purposes. Customers should validate and test their design implementation to confirm system functionality. 8.1 Application Information The LP5562 is designed for mobile applications with an input voltage VIN between 2.7 V to 5.5 V to support a 1S lithium-ion battery source. A microcontroller or other I2C host is required to initialize and configure the LP5562 after power-up. An internal of external 32-kHz clock is required. If multiple LP5562 devices are used to sequence multiple RGB LEDs, then the external 32-kHz clock input is required. The ADDRSEL0 and ADDRSEL1 pins can be used to allow unique sequencing of up to four LP5562 devices on the same I2C bus. The four LED current drivers can be configured up to 25.5-mA LED current each and are tolerant up to 6-V LED supply voltage. 8.2 Typical Application Figure 44 shows the typical application for LP5562 supporting one RGB LED and one White LED with the four LED current outputs. Figure 44. LP5562 Typical Application 8.2.1 Design Requirements For typical LED-driver applications, use the parameters listed in Table 44. Table 44. Design Parameters DESIGN PARAMETER EXAMPLE VALUE Minimum input voltage 2.7 V Maximum input voltage 5.5 V EN/VCC logic level 1.8 V R output current 24 mA G output current 20 mA B output current 22 mA WLED output current 18 mA PWM frequency 256 Hz 32-kHz clock source External Light engines 1, 2 and 3 Blink on/off Power-save mode Enabled |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |