AT43USB326 datasheet(67/102 Pages) ATMEL

67 / 102 page

AT43USB326

3313D–USB–04/06

Selective Suspend

and Resume

The host can selectively suspend and resume a port through the Set Port Feature

(PORT_SUSPEND) and Clear Port Feature (PORT_SUSPEND).

A port enters the suspend state after the microcontroller interprets the suspend request and

sets the appropriate bits of the Hub Port Control Register, HPCON. From this point on he hub

repeater hardware is responsible for proper actions in placing Ports 2:3 in the suspend mode.

For Port 1, the embedded function port, the hardware will stop responding to any normal bus

traffic, but the microcontroller firmware must place all external circuitry associated with the

function in the low-power state.

A port exits from the suspend state when the hub receives a Clear Port Feature

(PORT_SUSPEND) or Set Port Feature (PORT_RESET). If the Clear Port Feature

(PORT_SUSPEND) is directed towards Ports 2:3, the USB hardware drives a “K” downstream

for at least 20 ms followed by a low speed EOP. It then places the port in the enabled state. A

Clear Port Feature (PORT_SUSPEND) to Port 1 (the embedded function) causes the firmware

to wait 20 ms, take the embedded function out of the suspended state and then enable the

port.

The ports can also exit from the suspended state through a remote wakeup if this feature is

enabled. For Ports 2:3, this means detection of a connect/disconnect or an upstream directed

J to K signaling. Remote wakeup for the embedded function is initiated through an external

interrupt at INT0.

AT43USB326 датащи(PDF) 67 Page - ATMEL Corporation